transferring control to linux
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 1 line
Hi all,
Hello
Quoted 21 lines
we are porting u-boot/linux to a custom board based on mpc8280. After having made u-boot-1.1.4 work, we tried booting some test-configured linux 2.6.15 kernels.
If we start u-boot using Trace32 (lauterbach) all goes well and linux gets loaded, but if we do the same steps disconnecting Trace32, u-boot seems to work properly, but as soon as the control is transferred to linux all seems to be hanged, and the last words visible on the serial are:
[...]
## Loading RAMDisk Image at 00400000 ...Image Name: Test Ramdisk Image Image Type: PowerPC Linux RAMDisk Image (gzip compressed) Data Size: 1374924 Bytes = 1.3 MBLoad Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
## initrd at0x00400040...0x0054FB0B(len=1374924=0x14FACC)
Loading Ramdisk to07e4e000, end07f9dacc... OK
## Transferring control to Linux (at address 00000000) ...
Quoted 2 lines
We are wondering if this is an issue involving u-boot or if this is related to linux config (in this case sorry for being off-topic).
Had the same problem. Make sure your board-specific include defines the correct IMMR-address etc. and the bd_info structure is the same in u-boot and in linux.
After having checked that you should compile a minimal kernel, check the logbuffer for output (see DENX FAQ) and debug the kernel. In my case it hang in some console output function so that i had to fix the serial debug output the same way i had to fix u-boot before. Then the kernel just worked great :-)
Quoted 4 lines
Thanks for any help!!
Ciao,
Alberto
ciao
josef