Skip to contentSkip to conversation

i386 Vmi system header

RFC PATCH In review Zachary Amsden 1 participant 1 message Mar 13, 2006

lore
Share & tools
lore
#0 lore raw

RFC PATCH 13/24 i386 Vmi system header

Fairly straightforward code motion in system.h into the sub-arch layer. Affected functionality include control register accessors, which are virtualizable but with great overhead due to the #GP cost; wbinvd, and most importantly, halt and interrupt control, which is non-virtualizable.

Since read_cr4_safe can never fault on a VMI kernel (P5+ processor is required for VMI), we can omit the fault fixup, which does not play well with the VMI inline assembler, and just call read_cr4() directly.

Note that shutdown_halt is unused, but provided in case there is really a use for it. See arch/i386/kernel/smp.c for a potential call site during AP shutdown.

include/asm-i386/system.h +3 -74
Index: linux-2.6.16-rc5/include/asm-i386/system.h
===================================================================
@@ -9,6 +9,8 @@
 
 #ifdef __KERNEL__
 
+#include <mach_system.h>
+
 struct task_struct;	/* one of the stranger aspects of C forward declarations.. */
 extern struct task_struct * FASTCALL(__switch_to(struct task_struct *prev, struct task_struct *next));
 
@@ -83,69 +85,8 @@ __asm__ __volatile__ ("movw %%dx,%1\n\t"
 #define savesegment(seg, value) \
 	asm volatile("mov %%" #seg ",%0":"=rm" (value))
 
-/*
- * Clear and set 'TS' bit respectively
- */
-#define clts() __asm__ __volatile__ ("clts")
-#define read_cr0() ({ \
-	unsigned int __dummy; \
-	__asm__ __volatile__( \
-		"movl %%cr0,%0\n\t" \
-		:"=r" (__dummy)); \
-	__dummy; \
-})
-#define write_cr0(x) \
-	__asm__ __volatile__("movl %0,%%cr0": :"r" (x));
-
-#define read_cr2() ({ \
-	unsigned int __dummy; \
-	__asm__ __volatile__( \
-		"movl %%cr2,%0\n\t" \
-		:"=r" (__dummy)); \
-	__dummy; \
-})
-#define write_cr2(x) \
-	__asm__ __volatile__("movl %0,%%cr2": :"r" (x));
-
-#define read_cr3() ({ \
-	unsigned int __dummy; \
-	__asm__ ( \
-		"movl %%cr3,%0\n\t" \
-		:"=r" (__dummy)); \
-	__dummy; \
-})
-#define write_cr3(x) \
-	__asm__ __volatile__("movl %0,%%cr3": :"r" (x));
-
-#define read_cr4() ({ \
-	unsigned int __dummy; \
-	__asm__( \
-		"movl %%cr4,%0\n\t" \
-		:"=r" (__dummy)); \
-	__dummy; \
-})
-
-#define read_cr4_safe() ({			      \
-	unsigned int __dummy;			      \
-	/* This could fault if %cr4 does not exist */ \
-	__asm__("1: movl %%cr4, %0		\n"   \
-		"2:				\n"   \
-		".section __ex_table,\"a\"	\n"   \
-		".long 1b,2b			\n"   \
-		".previous			\n"   \
-		: "=r" (__dummy): "0" (0));	      \
-	__dummy;				      \
-})
-
-#define write_cr4(x) \
-	__asm__ __volatile__("movl %0,%%cr4": :"r" (x));
-#define stts() write_cr0(8 | read_cr0())
-
 #endif	/* __KERNEL__ */
 
-#define wbinvd() \
-	__asm__ __volatile__ ("wbinvd": : :"memory");
-
 static inline unsigned long get_limit(unsigned long segment)
 {
 	unsigned long __limit;
@@ -518,16 +459,7 @@ struct alt_instr { 
 
 #define set_wmb(var, value) do { var = value; wmb(); } while (0)
 
-/* interrupt control.. */
-#define local_save_flags(x)	do { typecheck(unsigned long,x); __asm__ __volatile__("pushfl ; popl %0":"=g" (x): /* no input */); } while (0)
-#define local_irq_restore(x) 	do { typecheck(unsigned long,x); __asm__ __volatile__("pushl %0 ; popfl": /* no output */ :"g" (x):"memory", "cc"); } while (0)
-#define local_irq_disable() 	__asm__ __volatile__("cli": : :"memory")
-#define local_irq_enable()	__asm__ __volatile__("sti": : :"memory")
-/* used in the idle loop; sti takes one instruction cycle to complete */
-#define safe_halt()		__asm__ __volatile__("sti; hlt": : :"memory")
-/* used when interrupts are already enabled or to shutdown the processor */
-#define halt()			__asm__ __volatile__("hlt": : :"memory")
-
+#define local_irq_save(x) do { typecheck(unsigned long,x); local_save_flags(x); local_irq_disable(); } while (0)
 #define irqs_disabled()			\
 ({					\
 	unsigned long flags;		\
@@ -535,9 +467,6 @@ struct alt_instr { 
 	!(flags & (1<<9));		\
 })
 
-/* For spinlocks etc */
-#define local_irq_save(x)	__asm__ __volatile__("pushfl ; popl %0 ; cli":"=g" (x): /* no input */ :"memory")
-
 /*
  * disable hlt during certain critical i/o operations
  */
include/asm-i386/mach-vmi/mach_system.h +216 -0

216 lines not on this page · raw message

include/asm-i386/mach-default/mach_system.h +80 -0

80 lines not on this page · raw message