Skip to contentSkip to conversation

Adds SNES mouse support to gamecon

PATCH New Raphael Assenat 1 participant 1 message Mar 21, 2006

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Adds SNES mouse support to gamecon

This patch adds SNES mouse support to the gamecon joystick driver and corresponding documentation to joystick-parport.txt

SNES gamepads and mice share the same type of interface so they both can be connected to the parallel port using a simple interface. Adding mouse support to a gamepad driver may sound funny at first, but doing so in this case makes it possible to connect and SNES gamepads and mice at the same time, on the same port.

This patch applies to today's (Mar 20, 2006) Linus git kernel at rsync.kernel.org/pub/scm/linux/kernel/git/torvalds/linux-2.6.git

---

Documentation/input/joystick-parport.txt +6 -5
index 88a011c..fa7bf93 100644
@@ -36,12 +36,12 @@ with them.
 
   All NES and SNES use the same synchronous serial protocol, clocked from
 the computer's side (and thus timing insensitive). To allow up to 5 NES
-and/or SNES gamepads connected to the parallel port at once, the output
-lines of the parallel port are shared, while one of 5 available input lines
-is assigned to each gamepad.
+and/or SNES gamepads and/or SNES mice connected to the parallel port at once, 
+the output lines of the parallel port are shared, while one of 5 available 
+input lines is assigned to each gamepad.
 
   This protocol is handled by the gamecon.c driver, so that's the one
-you'll use for NES and SNES gamepads.
+you'll use for NES, SNES gamepads and SNES mice.
 
   The main problem with PC parallel ports is that they don't have +5V power
 source on any of their pins. So, if you want a reliable source of power
@@ -106,7 +106,7 @@ A, Turbo B, Select and Start, and is con
 either a NES or NES clone and will work with this connection. SNES gamepads
 also use 5 wires, but have more buttons. They will work as well, of course.
 
-Pinout for NES gamepads                 Pinout for SNES gamepads
+Pinout for NES gamepads                 Pinout for SNES gamepads and mice
 
 	   +----> Power                   +-----------------------\
 	   |                            7 | o  o  o  o |  x  x  o  | 1
@@ -454,6 +454,7 @@ uses the following kernel/module command
 	  6  | N64 pad
 	  7  | Sony PSX controller
 	  8  | Sony PSX DDR controller
+	  9  | SNES mouse
 
   The exact type of the PSX controller type is autoprobed when used so
 hot swapping should work (but is not recomended).
drivers/input/joystick/gamecon.c +83 -15

157 lines not on this page · raw message