lm70: New hardware monitoring driver
Subsystems (2)
PATCH 13/14 lm70: New hardware monitoring driver
From: Kaiwan N Billimoria <kaiwan at designergraphix.com>
Content-Disposition: inline; filename=hwmon-lm70-new-driver.patch
This driver implements support for the National Semiconductor LM70 temperature sensor.
The LM70 temperature sensor chip supports a single temperature sensor. It communicates with a host processor (or microcontroller) via an SPI/Microwire Bus interface.
Communication with the LM70 is simple: when the temperature is to be sensed, the driver accesses the LM70 using SPI communication: 16 SCLK cycles comprise the MOSI/MISO loop. At the end of the transfer, the 11-bit 2's complement digital temperature (sent via the SIO line), is available in the driver for interpretation. This driver makes use of the kernel's in-core SPI support.
--- Documentation/hwmon/lm70 | 31 +++++++++ drivers/hwmon/Kconfig | 10 +++ drivers/hwmon/Makefile | 1 + drivers/hwmon/lm70.c | 165 ++++++++++++++++++++++++++++++++++++++++++++++ 4 files changed, 207 insertions(+)
Documentation/hwmon/lm70 new file +31 -0
@@ -0,0 +1,31 @@ +Kernel driver lm70 +========= + +Supported chip: + * National Semiconductor LM70 + Datasheet: http://www.national.com/pf/LM/LM70.html + +Author: + Kaiwan N Billimoria <kaiwan at designergraphix.com> + +Description +----------- + +This driver implements support for the National Semiconductor LM70 +temperature sensor. + +The LM70 temperature sensor chip supports a single temperature sensor. +It communicates with a host processor (or microcontroller) via an +SPI/Microwire Bus interface. + +Communication with the LM70 is simple: when the temperature is to be sensed, +the driver accesses the LM70 using SPI communication: 16 SCLK cycles +comprise the MOSI/MISO loop. At the end of the transfer, the 11-bit 2's +complement digital temperature (sent via the SIO line), is available in the +driver for interpretation. This driver makes use of the kernel's in-core +SPI support. + +Thanks to +--------- +Jean Delvare <khali at linux-fr.org> for mentoring the hwmon-side driver +development.
drivers/hwmon/Kconfig +10 -0
@@ -204,6 +204,16 @@ This driver can also be built as a module. If so, the module will be called lm63. +config SENSORS_LM70 + tristate "National Semiconductor LM70" + depends on HWMON && SPI_MASTER && EXPERIMENTAL + help + If you say yes here you get support for the National Semiconductor + LM70 digital temperature sensor chip. + + This driver can also be built as a module. If so, the module + will be called lm70. + config SENSORS_LM75 tristate "National Semiconductor LM75 and compatibles" depends on HWMON && I2C
drivers/hwmon/lm70.c new file +165 -0
165 lines not on this page · raw message
drivers/hwmon/Makefile +1 -0
@@ -28,6 +28,7 @@ obj-$(CONFIG_SENSORS_HDAPS) += hdaps.o obj-$(CONFIG_SENSORS_IT87) += it87.o obj-$(CONFIG_SENSORS_LM63) += lm63.o +obj-$(CONFIG_SENSORS_LM70) += lm70.o obj-$(CONFIG_SENSORS_LM75) += lm75.o obj-$(CONFIG_SENSORS_LM77) += lm77.o obj-$(CONFIG_SENSORS_LM78) += lm78.o
Signature · 1 line
Jean Delvare