tsec ethernet link bug?
Hi
I'm using a 8548CDS board and I have a link plugged into eth1 (but not eth0). When I run u-boot, it thinks that eth0 is plugged in and keeps trying tftp on that port.
I think there is a little bug in the code - here is a diff. Basically priv->link inadvertently gets set to 1 when the timeout case breaks out of the while loop inside the routine mii_parse_sr().
Could somebody please confirm if they have seen this?
thanks.
===============================================================
drivers/tsec.c +1 -1
@@ -363,7 +363,7 @@ uint mii_parse_sr(uint mii_reg, struct tif (i >PHY_AUTONEGOTIATE_TIMEOUT ) {puts (" TIMEOUT !\n" ); priv->link =0 ; -break ; +return 0 ; }if ((i++ %1000 ) ==0 ) {
================================================================