Was: boot failure, "DWARF2 unwinder stuck at 0xc0100199"
In-Reply-To: <[email protected]>
Quoted 16 lines · Badari Pulavarty
As you can see from the following stack - it shows
msync_interval() -> set_page_dirty() -> __set_page_dirty_buffers()But actual trace is (looking at the code):
msync_interval() -> msync_page_range() -> msync_pud_range() -> msync_pgd_range() -> msync_pte_range() -> set_page_dirty() -> __set_page_dirty_buffers()
Quoted 1 line
Why is it skipping all msync_page/pud/pgd/pte_range() routines ?
Sometimes this is caused by tail calls, i.e. when the last line of a function calls another function it can many times be optimized into a jump.
You can disable this by compiling with CONFIG_FRAME_POINTER=y.
Signature · 1 line
Chuck
Quoted 6 lines
Sometimes this is caused by tail calls, i.e. when the last line of a function calls another function it can many times be optimized into a jump.
You can disable this by compiling with
CONFIG_FRAME_POINTER=y.
Even that will not disable automatic inlining, which is probably causing most of the missing frames here.
-Andi