Skip to contentSkip to conversation

2.6.18-rc5-mm1 + all hotfixes -- BUG: MAX_STACK_TRACE_ENTRIES too low!

DISCUSSION Miles Lane 1 participant 1 message Sep 3, 2006 4 messages not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

A message that is not in the archive (sent off-list or not yet received): [email protected]

Miles Lane

author
#4 lore raw
Quoted 34 lines · Sam Ravnborg
Quoted 24 lines · Miles Lane
Quoted 23 lines · Sam Ravnborg

[ketchup -g 2.6-mm; make defconfig; make menuconfig]

[sam@neptun mm]$ grep LOCKDEP .config
CONFIG_LOCKDEP_SUPPORT=y
CONFIG_LOCKDEP=y
CONFIG_DEBUG_LOCKDEP=y
[sam@neptun mm]$ make

 CHK     include/linux/version.h
 CHK     include/linux/utsrelease.h
 CHK     include/linux/compile.h

MODPOST vmlinux
Kernel: arch/i386/boot/bzImage is ready (#3)
Building modules, stage 2.
MODPOST 1 modules
[sam@neptun mm]$ touch kernel/lockdep_internals.h
[sam@neptun mm]$ make

 CHK     include/linux/version.h
 CHK     include/linux/utsrelease.h
 CHK     include/linux/compile.h
 CC      kernel/lockdep.o
 CC      kernel/lockdep_proc.o
Quoted 8 lines
Quoted 3 lines

Works for me?

Miles - can you double check that you have CONFIG_LOCKDEP defined.

Ah, I suspect I was being a dufus. I was looking for the exact filename, since I rarely receive patches for anything other than C files. I probably overlooked it. I'm very sorry to have bothered you. BTW, yes, I had it defined.

Quoted 6 lines

No problem.
Can I request you to do a follow-up post to the mail at lkml just so people do not start to mistrust kbuild.

It takes quiet some time to gain trust but only little to loose it again so it would be very nice to close this one in public.

Sure. I didn't notice you had dropped LKML off the CC list in your reply.

Hey everyone, mea culpa. KBuild is working fine! :-)

Signature · 1 line
VGER BF report: U 0.500013