cpufreq and suspend
Quoted 11 lines
Quoted 6 lines
I would be grateful if you could have a look at:
http://lists.suspend2.net/lurker/message/20060827.234345.486617dc.en.html
Forgive me if this issue has been already mentioned, I can't seem to find a way to search through archives.
I'll go take a look at this.
-Mark Langsdorf
AMD, Inc.
Is there any hope for a solution to this problem, Mark et al?
Regards,
Luke
Quoted 10 lines
Quoted 2 lines
617dc.en.html
Quoted 5 lines
Quoted 3 lines
Forgive me if this issue has been already mentioned, I can't seem to find a way to search through archives.
I'll go take a look at this.
Is there any hope for a solution to this problem, Mark et al?
It's been a busy week, and I just secured the system necessary to do the testing.
Currently, I cannot reproduce with OpenSUSE 10.1 and the powersave tool. The system goes into S3 and comes out fine. Both cores are available and seem to be switching.
I'll set up suspend2 this afternoon and try again.
-Mark Langsdorf
AMD, Inc.
Quoted 11 lines · you
Quoted 10 lines
Quoted 1 line
617dc.en.html
Quoted 4 lines
Quoted 2 lines
Forgive me if this issue has been already mentioned, I can't seem to find a way to search through archives.
I'll go take a look at this.
Is there any hope for a solution to this problem, Mark et al?
Quoted 8 lines
It's been a busy week, and I just secured the system necessary to do the testing.
Currently, I cannot reproduce with OpenSUSE 10.1 and the powersave tool. The system goes into S3 and comes out fine. Both cores are available and seem to be switching.
I'll set up suspend2 this afternoon and try again.
Well, S3 doesn't work for me (doesn't want to wake up), thus I can't check how cpufreq behaves with it. The problem occurs with suspend to disk (just checked, not only with suspend2, but also with swsusp/powersave) - quite logically it's where the problem could occur, as it has to go through BIOS and kernel initialization phases again (I suppose suspend to RAM doesn't go through that). I should've mentioned it earlier.
For completeness, MB is Asus A8N-E with latest BIOS.
I wish you a fruitful hunting,
Luke
Quoted 7 lines
Quoted 7 lines
It's been a busy week, and I just secured the system necessary to do the testing.
Currently, I cannot reproduce with OpenSUSE 10.1 and the powersave tool. The system goes into S3 and comes out fine. Both cores are available and seem to be switching.
Quoted 8 lines
Quoted 1 line
I'll set up suspend2 this afternoon and try again.
Well, S3 doesn't work for me (doesn't want to wake up), thus I can't check how cpufreq behaves with it.
The problem occurs with suspend to disk (just
checked, not only with suspend2, but also with
swsusp/powersave)
I've tested "powersave -U" on a 4P/4C AMD internal reference design and on an HP Turion X2 laptop, both using the 1.60.2 driver in the SUSE 2.6.16.13 kernel. Both systems go into S4 properly and come out properly, and PowerNow! has entries for each core before and after suspend/resume.
This may be a MB specific problem.
Quoted 1 line
For completeness, MB is Asus A8N-E with latest BIOS.
Okay, I'll go try to dig one of those up.
-Mark Langsdorf
AMD, Inc.