Add timeouts during sense PGID, path verification and disband PGID.
Subsystems (2)
From: Cornelia Huck <[email protected]>
[S390] Add timeouts during sense PGID, path verification and disband PGID.
While the machine owns us an interrupt in these cases (and we should get one), reality isn't always like that...
Signed-off-by Cornelia Huck <[email protected]>
Signed-off-by Martin Schwidefsky <[email protected]>
---
drivers/s390/cio/device_fsm.c | 2 ++ drivers/s390/cio/device_ops.c | 3 +++ drivers/s390/cio/device_pgid.c | 8 ++++++++ 3 files changed, 13 insertions(+)
drivers/s390/cio/device_fsm.c +2 -0
@@ -349,6 +349,8 @@ ccw_device_done(struct ccw_device *cdev, sch =to_subchannel (cdev->dev.parent); +ccw_device_set_timeout (cdev,0 ); +if (state !=DEV_STATE_ONLINE )cio_disable_subchannel (sch);
drivers/s390/cio/device_ops.c +3 -0
@@ -216,6 +216,9 @@ ccw_device_call_handler(struct ccw_devic (stctl & SCSW_STCTL_PRIM_STATUS)))return 0 ; +/* Clear pending timers for device driver initiated I/O. */ +if (ending_status) +ccw_device_set_timeout (cdev,0 );/* * Now we are ready to call the device driver interrupt handler. */
drivers/s390/cio/device_pgid.c +8 -0
@@ -96,6 +96,9 @@ ccw_device_sense_pgid_start(struct ccw_d {int ret; +/* Set a timeout of 60s */ +ccw_device_set_timeout (cdev,60 *HZ ); + cdev->private->state =DEV_STATE_SENSE_PGID ; cdev->private->imask =0x80 ; cdev->private->iretry =5 ;
@@ -480,6 +483,8 @@ ccw_device_verify_start(struct ccw_devicccw_device_verify_done (cdev, -ENODEV );return ; } +/* After 60s path verification is considered to have failed. */ +ccw_device_set_timeout (cdev,60 *HZ );__ccw_device_verify_start (cdev); }
@@ -554,6 +559,9 @@ ccw_device_disband_irq(struct ccw_devicevoid ccw_device_disband_start (struct ccw_device *cdev) { +/* After 60s disbanding is considered to have failed. */ +ccw_device_set_timeout (cdev,60 *HZ ); + cdev->private->flags.pgid_single =0 ; cdev->private->iretry =5 ; cdev->private->imask =0x80 ;