Skip to contentSkip to conversation

Break out memory initialisation code from page_alloc.c to mem_init.c

PATCH Andrew Morton 2 participants 2 messages Nov 29, 2006 – Nov 30, 2006 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 8 lines · On Wed, 29 Nov 2006 18:00:47 +0000 [email protected] (Mel Gorman) wrote:

page_alloc.c contains a large amount of memory initialisation code which obscures the purpose of the file. This patch breaks out the initialisation code into a separate file to make page_alloc.c a bit easier to read.

This is a repost from a long time ago. At the time it was last posted, there was too much churn in page_alloc.c and it was put on the back-burner. However, there is still a lot going on in page_alloc.c so the time still might not be right.

yeah, it spits a 58k reject already. There's basically never a good time for this, but the best time is around 2.6.x-rc1.

#2 lore raw
Quoted 7 lines · Andrew Morton
Quoted 4 lines · On Wed, 29 Nov 2006 18:00:47 +0000 [email protected] (Mel Gorman) wrote:

page_alloc.c contains a large amount of memory initialisation code which obscures the purpose of the file. This patch breaks out the initialisation code into a separate file to make page_alloc.c a bit easier to read.

Quoted 6 lines
Quoted 4 lines

This is a repost from a long time ago. At the time it was last posted, there was too much churn in page_alloc.c and it was put on the back-burner. However, there is still a lot going on in page_alloc.c so the time still might not be right.

yeah, it spits a 58k reject already.

I'm not suprised.

Quoted 3 lines

There's basically never a good time for this,
but the best time is around 2.6.x-rc1.

Grand, I'll take another look around then. It's not very important anyway.

Thanks

Signature · 3 lines
Mel Gorman
Part-time Phd Student                          Linux Technology Center
University of Limerick                         IBM Dublin Software Lab