Skip to contentSkip to conversation

i2c for omap5912,help me

DISCUSSION 李玮 3 participants 3 messages Dec 8, 2006 – Dec 10, 2006 1 message not in the archive

lore
Share & tools
lore

李玮

author
#1 lore raw
In reply to a message not in the archive

Hi ,

I'm using an omap5912 and would like to light the led D3
on the board thru the i2c driver.
Now I can not see nothing in /proc/sys/dev/ and /dev, but I can see there is something about
i2c in /proc/bus/. I can not open the file,Could there
be something wrong with my opening the dev file ? I hope there is someone who knows my problem? Thanks in advance.
Below are the debug msg aswell as the code.

  int adapter_nr = 0;
  int file;
  char filename[20]; 
  sprintf(filename,"/dev/i2c-%d",adapter_nr);
   if ((file = open(filename,O_RDWR)) < 0) {
     printf("Error Opening File\n");
     exit(1);
   }

the file value is allways 1,Who can help me?Thanks!

#2 lore raw

Hi,

Does this help?

http://oskfordummies.hp.infoseek.co.jp/howto/led.html

Regards,
Ishigami

-----Original Message-----
From: 李玮 [mailto:[email protected]]
Sent: Thursday, December 07, 2006 10:51 PM
To: [email protected]
Subject: i2c for omap5912,help me

Hi ,

I'm using an omap5912 and would like to light the led D3
on the board thru the i2c driver.
Now I can not see nothing in /proc/sys/dev/ and /dev, but I can see there is something about
i2c in /proc/bus/. I can not open the file,Could there
be something wrong with my opening the dev file ? I hope there is someone who knows my problem? Thanks in advance.
Below are the debug msg aswell as the code.

  int adapter_nr = 0;
  int file;
  char filename[20]; 
  sprintf(filename,"/dev/i2c-%d",adapter_nr);
   if ((file = open(filename,O_RDWR)) < 0) {
     printf("Error Opening File\n");
     exit(1);
   }

the file value is allways 1,Who can help me?Thanks!

#3 lore raw
In reply to 李玮
Quoted 2 lines

I'm using an omap5912 and would like to light the led D3
on the board thru the i2c driver.

In the kernel, <asm/arch/tps65010.h> exports

extern int tps65010_set_led(unsigned led, unsigned mode); extern int tps65010_set_gpio_out_value(unsigned gpio, unsigned value);

which are used for those LEDs. D3 is connected to TPS65010 GPIO 2...