amba-pl010: clear error flags on rx error
PATCH 1/1 amba-pl010: clear error flags on rx error
The pl010 primecell documentation specifies that an error indicated via RSR should be cleared by a write to ECR. We didn't do this, which was causing errors to be re-reported on every call to pl010_rx_chars().
Doing a write to ECR once we detect an error appears to prevent the ep93xx console UART driver from going into a mode where it reports "ttyAM0: X input overrun(s)" every couple of keystrokes.
Signed-off-by Lennert Buytenhek <[email protected]>
drivers/serial/amba-pl010.c +2 -0
@@ -129,6 +129,8 @@ static void pl010_rx_chars(struct uart_p*/ rsr =readb (port->membase + UART01x_RSR) |UART_DUMMY_RSR_RX ;if (unlikely (rsr & UART01x_RSR_ANY)) { +writel (0 , port->membase + UART01x_ECR); +if (rsr & UART01x_RSR_BE) { rsr &= ~(UART01x_RSR_FE | UART01x_RSR_PE); port->icount.brk++;