Skip to contentSkip to conversation

Strange things on 2.6.19 for a dual-core CPU

DISCUSSION Pavel Troller 1 participant 1 message Dec 16, 2006 ACPI

lore
Share & tools
lore
#0 lore raw

Hi!
I've updated to vanilla 2.6.19 on my Pentium-D (dual-core x86_64) box.
Now I can't see even C1 in the /proc/acpi/processor/*/power output:

patrol@arcus:~$ cat /proc/acpi/processor/CPU1/power
active state:            C0
max_cstate:              C8
bus master activity:     00000000
maximum allowed latency: 2000 usec
states:
patrol@arcus:~$ cat /proc/acpi/processor/CPU2/power
active state:            C0
max_cstate:              C8
bus master activity:     00000000
maximum allowed latency: 2000 usec
states:

Another interesting thing is shown here:

patrol@arcus:~$ cat /proc/acpi/processor/CPU1/info
processor id:            0
acpi id:                 1
bus mastering control:   no
power management:        no
throttling control:      yes
limit interface:         yes
patrol@arcus:~$ cat /proc/acpi/processor/CPU2/info
processor id:            1
acpi id:                 2
bus mastering control:   no
power management:        no
throttling control:      no
limit interface:         no

As I remember, both cores were showing the same things formerly. The only line referring to CPUs during boot is
ACPI: Processor [CPU1] (supports 8 throttling states)
and CPU2 is not mentioned at all.

The last (but maybe not acpi-related) strange thing is that in /proc/cpuinfo,
CPU1 reports 6403.56 bogomips (as always, approximately twice the clock) and CPU2 8314.32 ones (too much). It's also very suspicious. Formerly the difference was very small.

Should I provide more info to debug these things, or is it OK ?
With regards, Pavel Troller