Skip to contentSkip to conversation

DVD-RAM cannot be mounted RW with 2.6.18/2.6.19

DISCUSSION A. Kalten 2 participants 2 messages Dec 16, 2006

lore
Share & tools
lore

A. Kalten

author
#0 lore raw

Hello,

DVD-RAM disks previously made with a Linux system can no longer be mounted in RW mode. For some reason, as indicated by the error message from the mount command, the disks are detected as being write-protected (which is not the case). To be able to write to these disks, the mount command must be issued again with the "-o remount" option.

The commands given are as follows. Although the file type in this example is ext2, the same behavior is seen also with the udf file type.

# modprobe ide-cd
# hdparm -d1 -X udma4 -k1 /dev/hde
# mount -t ext2 -o rw,noatime /dev/hde /cdrom
mount: block device /dev/hde is write-protected, mounting read-only
# mount -t ext2 -o remount,rw,noatime /dev/hde /cdrom

Now the DVD-RAM disk can be written normally, but there should be no need for the second mount command.

The kernel log for this command sequence seems to show nothing abnormal:

kernel: hde: ATAPI 39X DVD-ROM DVD-R-RAM CD-R/RW drive, 2048kB Cache, UDMA(66)
kernel: Uniform CD-ROM driver Revision: 3.20
kernel: hde: CHECK for good STATUS
kernel: cdrom: hde: mrw address space DMA selected
kernel: cdrom open: mrw_status 'not mrw'

Furthermore, if I attempt to check the unmounted DVD-RAM disk with e2fsck, the drive is still reported as read-only:

# e2fsck -p /dev/hde
e2fsck: Read-only file system while trying to open /dev/hde
Disk write-protected; use the -n option to do a read-only
check of the device.

However, as I indicated above, the disk is not write-protected.

I am reporting this problem on the lkml because of a hint that I discovered at this link:

http://lists.opensuse.org/packet-writing/2006-10/msg00000.html

Although this problem does not involve packet-writing, it may be related to the cdrom code.

Andrew Kalten

#1 lore raw
Quoted 43 lines · A. Kalten

Hello,

DVD-RAM disks previously made with a Linux system can no longer be mounted in RW mode. For some reason, as indicated by the error message from the mount command, the disks are detected as being write-protected (which is not the case). To be able to write to these disks, the mount command must be issued again with the "-o remount" option.

The commands given are as follows. Although the file type in this example is ext2, the same behavior is seen also with the udf file type.

# modprobe ide-cd
# hdparm -d1 -X udma4 -k1 /dev/hde
# mount -t ext2 -o rw,noatime /dev/hde /cdrom
mount: block device /dev/hde is write-protected, mounting read-only
# mount -t ext2 -o remount,rw,noatime /dev/hde /cdrom

Now the DVD-RAM disk can be written normally, but there should be no need for the second mount command.

The kernel log for this command sequence seems to show nothing abnormal:

kernel: hde: ATAPI 39X DVD-ROM DVD-R-RAM CD-R/RW drive, 2048kB Cache, UDMA(66)
kernel: Uniform CD-ROM driver Revision: 3.20
kernel: hde: CHECK for good STATUS
kernel: cdrom: hde: mrw address space DMA selected
kernel: cdrom open: mrw_status 'not mrw'

Furthermore, if I attempt to check the unmounted DVD-RAM disk with e2fsck, the drive is still reported as read-only:

# e2fsck -p /dev/hde
e2fsck: Read-only file system while trying to open /dev/hde
Disk write-protected; use the -n option to do a read-only
check of the device.

However, as I indicated above, the disk is not write-protected.

Quoted 7 lines

I am reporting this problem on the lkml because of a hint that I discovered at this link:

http://lists.opensuse.org/packet-writing/2006-10/msg00000.html

Although this problem does not involve packet-writing, it may be related to the cdrom code.

The problem I reported in the above link was related to UDF filesystem.

AFAIR, my DVD-RW have been formatted with "mkduffs --media-type=dvd",
which toggled a read-only flag at the FS level. I reformatted this DVD-RW with "mkudffs --media-type=dvdram" and the problem was gone.

I'm afraid this won't help you...
~~
laurent