Skip to contentSkip to conversation

Modular kernel (2.6.20) and software raid auto detection

DISCUSSION Andrew Walrond 2 participants 2 messages Feb 15, 2007

lore
Share & tools
lore
#0 lore raw

With my ide driver and the md stuff all built into the kernel, my software raid drives and associated /dev/md? devices are detected and created by the kernel.

With the md stuff built in but the ide driver modular and loaded later by udev, the drives are not detected.

So, I guessed that perhaps if I made the md stuff modular aswell and load it _after_ loading the ide driver, this might kickstart the auto-detect stuff. But it didn't :(

Is there a way to make auto-detection work without having the ide driver built in?

TIA

Andrew Walrond

#1 lore raw
Quoted 4 lines · On Thursday February 15, [email protected] wrote:

With my ide driver and the md stuff all built into the kernel, my software raid drives and associated /dev/md? devices are detected and created by the kernel.

Yep.

Quoted 3 lines

With the md stuff built in but the ide driver modular and loaded later by udev, the drives are not detected.

No, they aren't.

Quoted 4 lines

So, I guessed that perhaps if I made the md stuff modular aswell and load it _after_ loading the ide driver, this might kickstart the auto-detect stuff. But it didn't :(

No, it wouldn't.

Quoted 3 lines

Is there a way to make auto-detection work without having the ide driver built in?

Don't use in-kernel auto-detection. Use mdadm to do the auto-detection for you.

  mdadm --assemble --scan --homehost='<system>' --auto-update-homehost

might work providing your hostname has been set by the time it runs.

NeilBrown