jmr3927: do not call tc35815_killall().
Subsystems (3)
PATCH 1/1 jmr3927: do not call tc35815_killall().
No need to stop tc35815 before resetting the board. This fixes the build of tc35815 as a module. This also means there is no caller of tc35815_killall left, so remove that function also.
Signed-off-by Ralf Baechle <[email protected]>
arch/mips/jmr3927/rbhma3100/setup.c +0 -4
@@ -137,10 +137,6 @@ int jmr3927_ccfg_toeon = 0;static inline void do_reset (void ) { -#ifdef CONFIG_TC35815 -extern void tc35815_killall (void ); -tc35815_killall (); -#endif #if 1 /* Resetting PCI bus */ jmr3927_ioc_reg_out (0 ,JMR3927_IOC_RESET_ADDR );jmr3927_ioc_reg_out (JMR3927_IOC_RESET_PCI ,JMR3927_IOC_RESET_ADDR );
drivers/net/tc35815.c +0 -13
@@ -1703,19 +1703,6 @@ static void tc35815_chip_init(struct net_device *dev)spin_unlock_irqrestore (&lp->lock, flags); } -/* XXX */ -void -tc35815_killall (void ) -{ -struct net_device *dev; - -for (dev = root_tc35815_dev; dev; dev = ((struct tc35815_local *)dev->priv)->next_module) { -if (dev->flags&IFF_UP ){ - dev->stop (dev); - } - } -} -static struct pci_driver tc35815_driver = { .name =TC35815_MODULE_NAME , .probe = tc35815_probe,