Skip to contentSkip to conversation

kprobes breaks BUG_ON

S390 Martin Schwidefsky 1 participant 1 message Mar 5, 2007 s390

lore
Share & tools
lore
#0 lore raw

From: Martin Schwidefsky <[email protected]>

[S390] kprobes breaks BUG_ON

The illegal operation handler calls the die notifier with DIE_BPT to let kprobes pick up its breakpoint. If kprobes does not find its breakpoint it returns NOTIFY_STOP instead of NOTIFY_DONE. Since we use stop_machine_run on s390 to arm/disarm the kprobes breakpoints the race that kprobe_handler tries to solve by checking for the kprobes breakpoints does not exist. Removing the check makes BUG_ON working again.

---

 arch/s390/kernel/kprobes.c |   21 +++++++--------------
 1 files changed, 7 insertions(+), 14 deletions(-)
arch/s390/kernel/kprobes.c +7 -14
diff -urpN linux-2.6/arch/s390/kernel/kprobes.c linux-2.6-patched/arch/s390/kernel/kprobes.c
@@ -337,21 +337,14 @@ static int __kprobes kprobe_handler(stru
 	}
 
 	p = get_kprobe(addr);
-	if (!p) {
-		if (*addr != BREAKPOINT_INSTRUCTION) {
-			/*
-			 * The breakpoint instruction was removed right
-			 * after we hit it.  Another cpu has removed
-			 * either a probepoint or a debugger breakpoint
-			 * at this address.  In either case, no further
-			 * handling of this interrupt is appropriate.
-			 *
-			 */
-			ret = 1;
-		}
-		/* Not one of ours: let kernel handle it */
+	if (!p)
+		/*
+		 * No kprobe at this address. The fault has not been
+		 * caused by a kprobe breakpoint. The race of breakpoint
+		 * vs. kprobe remove does not exist because on s390 we
+		 * use stop_machine_run to arm/disarm the breakpoints.
+		 */
 		goto no_kprobe;
-	}
 
 	kcb->kprobe_status = KPROBE_HIT_ACTIVE;
 	set_current_kprobe(p, regs, kcb);