Skip to contentSkip to conversation

no boot with 2.6.21-rc3 and later

BUG Bob Tracy 2 participants 2 messages Mar 18, 2007

lore
Share & tools
lore

Bob Tracy

author
#0 lore raw

Platform is a Dell CPxJ 650GT notebook. Attempts to boot 2.6.21-rc3 and -rc4 produce the following console output:

(apparently normal boot)
...
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller at PCI slot 0000:00:07.1
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later

    ide0: BM-DMA at 0x0860-0x0867, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0x0868-0x086f, BIOS settings: hdc:DMA, hdd:pio

(hangs here)

The next two lines of output for 2.6.21-rc2 and earlier are:
Probing IDE interface ide0...
hda: TOSHIBA MK3017GAP, ATA DISK drive

Any idea what's going on here?

Signature · 4 lines
-----------------------------------------------------------------------
Bob Tracy                   WTO + WIPO = DMCA? http://www.anti-dmca.org
[email protected]
-----------------------------------------------------------------------
#1 lore raw

(added Bartlomiej to CC)

Quoted 11 lines · Bob Tracy

Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller at PCI slot 0000:00:07.1
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later

    ide0: BM-DMA at 0x0860-0x0867, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0x0868-0x086f, BIOS settings: hdc:DMA, hdd:pio

(hangs here)
The next two lines of output for 2.6.21-rc2 and earlier are:
Probing IDE interface ide0...
hda: TOSHIBA MK3017GAP, ATA DISK drive

Looks like it's related to some change in drivers/ide. As there have been only 13 patches in this area between rc2 and rc3, it should take only 3 or 4 reboots to figure the offending patch using git-bisect - could you please give it a try?

Thanks,

Signature · 1 line
Jiri Kosina