U-Boot 1.2 - Cannot run hello_world - Coldfire
A message that is not in the archive (sent off-list or not yet received): [email protected]
-----Original Message-----
From: [email protected] [mailto:u-boot-users-bounces at lists.sourceforge.net]On Behalf Of Arun Biyani
Sent: 15 June, 2007 Friday 11:00 PM
To: Wolfgang Denk
Cc: u-boot-users at lists.sourceforge.net
Subject: Re: [U-Boot-Users] U-Boot 1.2 - Cannot run hello_world - Coldfire
Quoted 7 lines · Wolfgang Denk
Eventually you did not download the binary image?
Best regards,
Wolfgang Denk
This morning, I also tried to run the .bin file (hello_world.bin). U-Boot just hung up. Current status
is, the hello_world program in the distribution (unmodified) does not run on Coldfire based board.
I tried this on our target board as well as a CSB360 board from Cogent Computers. I tried both
the hello_world.srec file and the hello_world.bin file.
Any ideas as to what I can do to make simple applications run in U-Boot on Coldfire? Has anyone
else tried this?
Thx
Hi Arun,
There is a specific way to run a bin file. First you have to load to a specific memory location let's say 0x2000. You have find the entry point address of the bin from it's symbol table and assuming the flash start address of the bin file 0, add 0x2000 to know the entry point address of the bin in the memory just loaded. Now say go "address" on the CLI. The program will run. Every time you load to a different address you need to find the actual physical address. That's why loading an ELF is easier than a bin from CLI. The same bin or srec can be burnt and run from the flash, but running a bin would involve this much to do be done.
Thanks and Regards
Ganesh Chandra Patro
SoftDel Systems Ltd
"ACROPOLIS", 2nd Floor
Marol Maroshi
Military Road
Andheri(East)
Mumbai - 400 059