Skip to contentSkip to conversation

BIOS does not recognize 500GB-disk

DISCUSSION Hadmut Danisch 3 participants 4 messages Jul 3, 2007 – Jul 4, 2007 libata

lore
Share & tools
lore
#0 lore raw

Hi,

just a question:

I have an older computer with a ASRock K7VT4A Pro mainboard and a VIA sata controller.

A 320GB Seagate SATA disk worked pretty well with that board, but now I replaced it with a 500GB Western Digital SATA, and the BIOS does not recognize that new disk, allthough I've updated the BIOS to the latest available version. The disk is not available under Linux (latest Ubuntu, 2.6.20).

I guess it is a BIOS problem, since the disk works in a different, newer machine with a newer mainboard.

Is there any way to have Linux to ignore the BIOS and to access that disk even if the BIOS didn't recognize it?

regards
Hadmut

#1 lore raw
Quoted 23 lines · Hadmut Danisch

Hi,

just a question:

I have an older computer with a ASRock K7VT4A Pro mainboard and a VIA sata controller.

A 320GB Seagate SATA disk worked pretty well with that board, but now I replaced it with a 500GB Western Digital SATA, and the BIOS does not recognize that new disk, allthough I've updated the BIOS to the latest available version. The disk is not available under Linux (latest Ubuntu, 2.6.20).

I guess it is a BIOS problem, since the disk works in a different, newer machine with a newer mainboard.

Is there any way to have Linux to ignore the BIOS and to access that disk even if the BIOS didn't recognize it?

regards
Hadmut

Quoted 5 lines

-
To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html

Turn off NCQ on the drive, limit to 1.5GBps operation, try again, I have the same issue with a new RAPTOR (NCQ) and old motherboard.

Justin.

#3 lore raw
In reply to Hadmut Danisch
Quoted 11 lines · Hadmut Danisch

Hi,

just a question:

I have an older computer with a ASRock K7VT4A Pro mainboard and a VIA sata controller.

A 320GB Seagate SATA disk worked pretty well with that board, but now I replaced it with a 500GB Western Digital SATA, and the BIOS does not recognize that new disk, allthough I've updated the BIOS to the latest available version. The disk is not available under Linux (latest Ubuntu, 2.6.20).

Please post boot dmesg.

Signature · 1 line
tejun
#2 lore raw
In reply to Justin Piszcz
Quoted 3 lines · Justin Piszcz

Turn off NCQ on the drive, limit to 1.5GBps operation, try again, I have the same issue with a new RAPTOR (NCQ) and old motherboard.

Yup, that was the problem. The VIA chipset did not support SATA-II. I had to set a jumper on the disk to slow it down to SATA-I. Unfortunately, they didn't tell that jumper setting on the disk's sticker, and the disk didn't come with a jumper, so it was not obvious.

Thanks and regards

Hadmut