Skip to contentSkip to conversation

a question about mpc8xx linux

DISCUSSION poorbeyond 3 participants 4 messages Jul 27, 2007 – Aug 1, 2007

lore
Share & tools
lore

poorbeyond

author
#0 lore raw

my cpu is MPC860, use u-boot-1.1.4, linux-2.6.20.14

i use the "tftp 300000 uImage" command download kernel image,

then use the "bootm 300000" command boot the image.

i found the bootm cmd entered the /arch/ppc/kernel/head_8xx.s, stop at the instruction "rfi". is it right? after the instruction, where does the code go normally ? what should i do now?

thanks

.globl __start
__start:
mr r31,r3 /* save parameters */
mr r30,r4
mr r29,r5
mr r28,r6
mr r27,r7

/* We have to turn on the MMU right away so we get cache modes
* set correctly.
*/
bl initial_mmu

/* We now have the lower 8 Meg mapped into TLB entries, and the caches
* ready to work.
*/

turn_on_mmu:
mfmsr r0
ori r0,r0,MSR_DR|MSR_IR
mtspr SPRN_SRR1,r0
lis r0,start_here@h
ori r0,r0,start_here@l
mtspr SPRN_SRR0,r0
SYNC
rfi /* enables MMU */

poorbeyond
2007-07-27

#1 lore raw
Quoted 5 lines · poorbeyond

my cpu is MPC860, use u-boot-1.1.4, linux-2.6.20.14

i use the "tftp 300000 uImage" command download kernel image,

then use the "bootm 300000" command boot the image.

You'll need either a device-tree-aware u-boot or 8xx cuImage support; you can get the latter from the patchset I posted recently.

Quoted 2 lines

i found the bootm cmd entered the /arch/ppc/kernel/head_8xx.s, stop at the instruction "rfi". is it right? after the instruction, where does the code go normally ? what should i do now?

The rfi transfers control to start_here:

-Scott

#2 lore raw
Quoted 10 lines · Scott Wood
Quoted 5 lines · poorbeyond

my cpu is MPC860, use u-boot-1.1.4, linux-2.6.20.14

i use the "tftp 300000 uImage" command download kernel image,

then use the "bootm 300000" command boot the image.

You'll need either a device-tree-aware u-boot or 8xx cuImage support; you can get the latter from the patchset I posted recently.

Sorry, I missed that you're using arch/ppc rather than arch/powerpc.

arch/ppc doesn't require a device tree, though it would be good to switch to arch/powerpc once my 8xx fixes go in -- arch/ppc is deprecated.

-Scott

#3 lore raw
In reply to poorbeyond

how do you know execution stop at "rfi" instruction.i think it seems it stop at "rfi" instruction when debugging through debugger, but it does n't . you check it by putting break point in the later functions e.g start_here, machine_init etc.

---------------------------------
5, 50, 500, 5000. Store N number of mails in your inbox. Click here.