setup and detect 2nd phy on MCF5275 in FEC driver
PATCH 1/1 setup and detect 2nd phy on MCF5275 in FEC driver
From: Mike Cruse <[email protected]>
Added code to recognize the second interface on M5275 boards.
Signed-off-by Greg Ungerer <[email protected]>
---
drivers/net/fec.c +23 -0
@@ -1426,6 +1427,29 @@ *gpio_pehlpar = 0xc0; }#endif + +#if defined(CONFIG_M527x) +/* Set up gpio outputs for MII lines */ + { +volatile u8 *gpio_par_fec; +volatile u16 *gpio_par_feci2c; + + gpio_par_feci2c = (volatile u16 *)(MCF_IPSBAR +0x100082 ); +/* Set up gpio outputs for FEC0 MII lines */ + gpio_par_fec = (volatile u8 *)(MCF_IPSBAR +0x100078 ); + + *gpio_par_feci2c |=0x0f00 ; + *gpio_par_fec |=0xc0 ; + +#if defined(CONFIG_FEC2 ) +/* Set up gpio outputs for FEC1 MII lines */ + gpio_par_fec = (volatile u8 *)(MCF_IPSBAR +0x100079 ); + + *gpio_par_feci2c |=0x00a0 ; + *gpio_par_fec |=0xc0 ; +#endif /* CONFIG_FEC2 */ + } +#endif /* CONFIG_M527x */ }static void __inline__fec_set_mii (struct net_device *dev,struct fec_enet_private *fep)