Skip to contentSkip to conversation

HowTo crashkernel hibernation (was: [PATH 0/1] Kexec jump - v2 - the first step to kexec based hibernation)

DISCUSSION Al Boldi 1 participant 1 message Jul 31, 2007

lore
Share & tools
lore

Al Boldi

author
#0 lore raw
Quoted 9 lines · Pavel Machek
Quoted 7 lines

3. Boot kernel compiled for normal usage, the reserved crash kernel memory region must be added to kernel command line as following:

crashkernel=<XX>M@<XX>M

Where, <XX> should be replaced by the real memory size and position.

I used crashkernel=64M@64M .

It's good to see that people finally try this.

I used crashkernel=16M@16M, which is the absolute minimum I managed to have the crashkernel boot successfully.

Quoted 3 lines
Quoted 3 lines

4. Load kernel compiled for hibernating usage as a crashdump kernel with kexec, the same kernel as that of 3 can be used if CONFIG_RELOCATABLE=y is selected.

That's not enough. You have to set the CONFIG_PHYSICAL_START to 1,000,000 for a 16M start. That's because the crashkernel only supports vmlinux, which cannot be relocatable.

Quoted 24 lines
Quoted 9 lines

The kernel command line option as following must be appended to kernel command line.

kexec_jump_buf_pfn=cat /sys/kernel/kexec_jump_buf_pfn

For example, the shell command line can be as follow:

kexec -p /boot/vmlinux --args-linux --append="root=/dev/hdb signal kexec_jump_buf_pfn=cat /sys/kernel/kexec_jump_buf_pfn"

I think I followed the instructions closely. Now I'm trying to do

kexec -p /data/l/linux/vmlinux --args-linux --append="init=/bin/bash kexec_jump_buf_pfn=cat /sys/kernel/kexec_jump_buf_pfn"

but it tells me:

Invalid memory segment 0x100000 - 0x7a0fff

(and nothing in dmesg)

If I try to load bzImage (corresponding to vmlinux I tried to use), I get:

Quoted 7 lines
root@amd:~# kexec -p /data/l/linux/arch/i386/boot/bzImage
--append="init=/bin/bash \ kexec_jump_buf_pfn=`cat
/sys/kernel/kexec_jump_buf_pfn`" Could not find a free area \ of memory of
9000 bytes... locate_hole failed
root@amd:~#

What am I doing wrong?

Nothing, but the doc isn't really clear on this, and an update is probably in order.

Thanks!

--
Al