Skip to contentSkip to conversation

Bluez-3.18 Headset and ALSA

Bluez-users Alexander Mette 1 participant 1 message Sep 11, 2007 Bluetooth drivers

lore
Share & tools
lore
#0 lore raw

Hello alltogether,

I'm trying to get a Plantronics Discovery 665 working with my Thinkpad R60 (Broadcom Corp / BCM2045B) to do VoIP.

After some digging on the net to be able to distinguish the different approaches in the first place (kernel module bt-sco, bluetooth-alsa) and some trial and error (kernel module didn't compile, bluetooth-alsa sometimes just gives deafening noise to the other side - sometimes it works just great), I found out, that both are obsolete. So why bother with getting bluetooth-alsa running, when the present is so close... ;)

After emerging (Gentoo) the unstable marked bluez-libs and bluez-utils 3.18 I followed the advice at
http://wiki.bluez.org/wiki/HOWTO/AudioDevices

Then I ran

	$ mplayer -ao alsa:device=bluetooth test.wav
and get
	[AO_ALSA] alsa-lib: pcm_bluetooth.c:1189:(bluetooth_init) Connection fail

Removing the "pcm.bluetooth" section from /etc/asound.conf gives me an
[AO_ALSA] alsa-lib: pcm.c:2144:(snd_pcm_open_noupdate) Unknown PCM bluetooth
error from mplayer and as the error first mentioned above comes
from "pcm_bluetooth.c", I'm pretty sure that I'm at the right place here. ;)

Very cool solution, just install bluez and tune your asound.conf - kudos for that implementation! :)

But this bug really sucks and I'm lost at this point.
I never was much into bluez, though I got ppp-dialup-connection and SyncML over bluetooth working before (bluez-2.xx) - and apparantly the upgrade didn't at least break the second one(though the view of my new kdebluetooth made me fear that)! :)
Only clue, that I found is from the above-mentioned link: "Make sure the audio service is installed and enabled"
- Gentoo automatically installs a file /etc/bluetooth/audio.service
so I figure, everything is ok.
BUT: Removing that file and restarting bluetooth as well as alsa doesn't make
any difference

Is there a way to see the successfully started services? Only thing I could think of is:
--------------------------

# hciconfig -a
..
Service Classes: Unspecified
..
--------------------------
So no services at all??

In the /etc/asound.conf I have the following(of course with correct MAC-address):
--------------------------

pcm.bluetooth {
        type bluetooth
        device "00:11:22:33:44:55"
        profile voice
}

--------------------------
The "profile" I found on some mailing-list post... before I tried with "preference", which is mentioned on
http://wiki.bluez.org/wiki/Audio
But doesn't do any difference.

Any ideas and help are appreciated! :)
Thanks and

greets
amette

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Bluez-users mailing list [email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-users