Skip to contentSkip to conversation

Hibernation: Check if ACPI is enabled during restore in the right place

PATCH RESEND Superseded Rafael J. Wysocki 1 participant 1 message Sep 12, 2007

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH RESEND 1/1 Hibernation: Check if ACPI is enabled during restore in the right place

From: Rafael J. Wysocki <[email protected]>

The following scenario leads to total confusion of the platform firmware on some boxes (eg. HPC nx6325):
* Hibernate with ACPI enabled
* Resume passing "acpi=off" to the boot kernel

To prevent this from happening it's necessary to check if ACPI is enabled (and enable it if that's not the case) _right_ _after_ control has been transfered from the boot kernel to the image kernel, before device_power_up() is called (ie. with interrupts disabled).  Enabling ACPI after calling device_power_up() turns out to be insufficient.

For this reason, introduce new hibernation callback ->leave() that will be executed before device_power_up() by the restored image kernel.  To make it work, it also is necessary to move swsusp_suspend() from swsusp.c to disk.c (it's name is changed to "create_image", which is more up to the point).

---
 drivers/acpi/sleep/main.c |    7 ++++-
 include/linux/suspend.h   |    7 +++++
 kernel/power/disk.c       |   58 +++++++++++++++++++++++++++++++++++++++++++++-
 kernel/power/power.h      |    1 
 kernel/power/swsusp.c     |   33 --------------------------
 5 files changed, 70 insertions(+), 36 deletions(-)
drivers/acpi/sleep/main.c +6 -1
Index: linux-2.6.23-rc6/drivers/acpi/sleep/main.c
===================================================================
@@ -238,13 +238,17 @@ static int acpi_hibernation_enter(void)
 	return ACPI_SUCCESS(status) ? 0 : -EFAULT;
 }
 
-static void acpi_hibernation_finish(void)
+static void acpi_hibernation_leave(void)
 {
 	/*
 	 * If ACPI is not enabled by the BIOS and the boot kernel, we need to
 	 * enable it here.
 	 */
 	acpi_enable();
+}
+
+static void acpi_hibernation_finish(void)
+{
 	acpi_leave_sleep_state(ACPI_STATE_S4);
 	acpi_disable_wakeup_device(ACPI_STATE_S4);
 
@@ -274,6 +278,7 @@ static struct platform_hibernation_ops a
 	.finish = acpi_hibernation_finish,
 	.prepare = acpi_hibernation_prepare,
 	.enter = acpi_hibernation_enter,
+	.leave = acpi_hibernation_leave,
 	.pre_restore = acpi_hibernation_pre_restore,
 	.restore_cleanup = acpi_hibernation_restore_cleanup,
 };
include/linux/suspend.h +7 -0
Index: linux-2.6.23-rc6/include/linux/suspend.h
===================================================================
@@ -156,6 +156,12 @@ extern void mark_free_pages(struct zone 
  *	Called after the nonboot CPUs have been disabled and all of the low
  *	level devices have been shut down (runs with IRQs off).
  *
+ * @leave: Perform the first stage of the cleanup after the system sleep state
+ *	indicated by @set_target() has been left.
+ *	Called right after the control has been passed from the boot kernel to
+ *	the image kernel, before the nonboot CPUs are enabled and before devices
+ *	are resumed.  Executed with interrupts disabled.
+ *
  * @pre_restore: Prepare system for the restoration from a hibernation image.
  *	Called right after devices have been frozen and before the nonboot
  *	CPUs are disabled (runs with IRQs on).
@@ -170,6 +176,7 @@ struct platform_hibernation_ops {
 	void (*finish)(void);
 	int (*prepare)(void);
 	int (*enter)(void);
+	void (*leave)(void);
 	int (*pre_restore)(void);
 	void (*restore_cleanup)(void);
 };
kernel/power/disk.c +57 -1

76 lines not on this page · raw message

kernel/power/power.h +0 -1
Index: linux-2.6.23-rc6/kernel/power/power.h
===================================================================
@@ -183,7 +183,6 @@ extern int swsusp_swap_in_use(void);
 extern int swsusp_check(void);
 extern int swsusp_shrink_memory(void);
 extern void swsusp_free(void);
-extern int swsusp_suspend(void);
 extern int swsusp_resume(void);
 extern int swsusp_read(unsigned int *flags_p);
 extern int swsusp_write(unsigned int flags);
kernel/power/swsusp.c +0 -33
Index: linux-2.6.23-rc6/kernel/power/swsusp.c
===================================================================
@@ -270,39 +270,6 @@ int swsusp_shrink_memory(void)
 	return 0;
 }
 
-int swsusp_suspend(void)
-{
-	int error;
-
-	if ((error = arch_prepare_suspend()))
-		return error;
-
-	local_irq_disable();
-	/* At this point, device_suspend() has been called, but *not*
-	 * device_power_down(). We *must* device_power_down() now.
-	 * Otherwise, drivers for some devices (e.g. interrupt controllers)
-	 * become desynchronized with the actual state of the hardware
-	 * at resume time, and evil weirdness ensues.
-	 */
-	if ((error = device_power_down(PMSG_FREEZE))) {
-		printk(KERN_ERR "Some devices failed to power down, aborting suspend\n");
-		goto Enable_irqs;
-	}
-
-	save_processor_state();
-	if ((error = swsusp_arch_suspend()))
-		printk(KERN_ERR "Error %d suspending\n", error);
-	/* Restore control flow magically appears here */
-	restore_processor_state();
-	/* NOTE:  device_power_up() is just a resume() for devices
-	 * that suspended with irqs off ... no overall powerup.
-	 */
-	device_power_up();
- Enable_irqs:
-	local_irq_enable();
-	return error;
-}
-
 int swsusp_resume(void)
 {
 	int error;

-
To unsubscribe from this list: send the line "unsubscribe linux-acpi" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html