Skip to contentSkip to conversation

raid5 growing question

DISCUSSION Justin Piszcz 2 participants 2 messages Oct 5, 2007 – Oct 6, 2007 1 message not in the archive MD RAID

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive
Quoted 12 lines · Shane

Hello all,

I have a raid5 softraid array using 6x320GB SATA drives. I would like to reconfigure it to be 3x1tb SATA. Is there a way to do this using the grow feature of mdadm. IE by swapping 3 of the 320GB drives out for the 3 1TB drives allowing the resyncs to occur between swapping and then somehow tell mdadm to take the remaining three 320GB drives out of the array or would I need to just create a new array somehow, copy the data over and just shut the first array right down?

Quoted 10 lines

Thanks,
Shane

Signature · 5 lines
http://www.cm.nu/~shane/
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html

There may be a way but it would be tricky, why not just move the data off to another 1-2TB host and then transfer it back via NFS or RSYNC?

Justin.

#2 lore raw
In reply to a message not in the archive

Shane,

Please take the following with some suspicion.

I used raidreconf to add drives to an array, so I assume the grow functionality can at least do the same.

I wonder: if you have less than 1TB of data then you can:
1 fail one 320GB disk (array now degraded!)
2 use the port to install 1x1TB as a degraded 2-disk RAID5 3 copy all the data across
4 remove the 5x320GB
5 install the other 2x1TB
may need to resync the 2x before growing to 3x?
6 grow to 3x1TB RAID5

If you *do* have a spare port then in step 2 you can create a degraded 3x1TB and step 6 is a simple resync when you add the missing third disk. You can copy the full 1.6TB across in this case.

Naturally, all this "degraded" means there is a real risk to your data for a few hours, but you knew that.

However, when I do not have ports to play with I take the slow solution and create the new RAID externally (using USB or another computer over a net - there is always another computer around for this job).

Good luck.

Eyal

Quoted 14 lines · Shane

Hello all,

I have a raid5 softraid array using 6x320GB SATA drives. I would like to reconfigure it to be 3x1tb SATA. Is there a way to do this using the grow feature of mdadm. IE by swapping 3 of the 320GB drives out for the 3 1TB drives allowing the resyncs to occur between swapping and then somehow tell mdadm to take the remaining three 320GB drives out of the array or would I need to just create a new array somehow, copy the data over and just shut the first array right down?

Thanks,
Shane

Signature · 1 line
Eyal Lebedinsky	([email protected])