Skip to contentSkip to conversation

Laptop's HDD

DISCUSSION Alberto Gonzalez 6 participants 6 messages Nov 4, 2007 – Nov 12, 2007

lore
Share & tools
lore
#0 lore raw

Hi,

Maybe some of you have been hearing lately about a problem with laptop's hard disk drives being killed by *insert Linux distro here* [1]

The problem comes from a very high rate of load/unload cycles of the heads that reaches the 300.000-600.000 limit in 2-3 years (with smartmontools it can checked it with "smartctl -A /dev/sda") . There are reports of HDD dying even earlier for this problem [2]

For what I've read, it's not that Linux is doing anything special to your hard disk, it's the BIOS settings that take care of killing your disk sooner than later. However, I'm asking on this list because the problem seems to have started with kernel 2.6.10 [3].

Windows seems to override the BIOS settings, so hardware vendors have never cared about this problem.

So my question is: Is this something the (Linux) kernel should care about or should distributions care about it with userspace tools?

By the way, this settings seem to be there in order to save power. However, loading/unloading the heads ~3 times per minute doesn't seem like a very good powersaving policy. Couldn't this be one of the reasons why Linux is using generally more power than Windows?

Regards,
Alberto.

[1] - http://beranger.org/index.php?page=diary&2007/10/24/18/07/21
- http://ubuntudemon.wordpress.com/2007/10/26/laptop-hardrive-killer-bug/

[2] -
http://ubuntudemon.wordpress.com/2007/10/27/laptop-hardrive-killer-bug-is-worse-than-i-thought/#comment-31490
http://paul.luon.net/journal/hacking/BrokenHDDs.html

[3] - https://www.redhat.com/archives/fedora-list/2005-March/msg00463.html

#1 lore raw
Quoted 4 lines · Alberto Gonzalez

Hi,

Maybe some of you have been hearing lately about a problem with laptop's hard disk drives being killed by *insert Linux distro here* [1]

I asked about this on the fedora devel list:
http://www.redhat.com/archives/fedora-devel-list/2007-October/msg02324.html

I don't think the kernel should worry about this.
I don't even think distros should change the default settings of the BIOS/disk.

Up to and including Fedora 7 on my laptop, the disk did a load cycle on average once every 48 seconds. Mounting the filesystems noatime changed this to once every 108 seconds, which is a little aggressive still but not too bad.

Note fedora 8 will have the relatime option on by default for all filesystems.

Pádraig.

#2 lore raw
In reply to Alberto Gonzalez
Quoted 4 lines · Alberto Gonzalez

The problem comes from a very high rate of load/unload cycles of the heads that reaches the 300.000-600.000 limit in 2-3 years (with smartmontools it can checked it with "smartctl -A /dev/sda") . There are reports of HDD dying even earlier for this problem [2]

I use:

# hdparm -B 255 /dev/hda

to get rid of the problem with an ATA disk where I do not care that much about power consumption. I do not know what the equivalent for a SATA disk would be, but chances are it will be easier to track it down with the reference above.

Maciej

#3 lore raw
Quoted 9 lines · Maciej W. Rozycki
Quoted 1 line · Alberto Gonzalez

The problem comes from a very high rate of load/unload cycles of the heads that reaches the 300.000-600.000 limit in 2-3 years (with smartmontools it can checked it with "smartctl -A /dev/sda") . There are reports of HDD dying even earlier for this problem [2]

I use:

# hdparm -B 255 /dev/hda

to get rid of the problem with an ATA disk where I do not care that much about power consumption. I do not know what the equivalent for a SATA disk would be, but chances are it will be easier to track it down with the reference above.

Although other power management features exist for SATA, for most hdparm stuff PATA and SATA are pretty much the same. Same command set, simply a new bus over which to transmit the commands. A great deal of early SATA is actually bridged PATA, even.

Jeff

#4 lore raw
In reply to Maciej W. Rozycki
Quoted 12 lines · Maciej W. Rozycki
Quoted 3 lines · Alberto Gonzalez

The problem comes from a very high rate of load/unload cycles of the heads that reaches the 300.000-600.000 limit in 2-3 years (with smartmontools it can checked it with "smartctl -A /dev/sda") . There are reports of HDD dying even earlier for this problem [2]

I use:

# hdparm -B 255 /dev/hda
Quoted 11 lines

to get rid of the problem with an ATA disk where I do not care that much about power consumption. I do not know what the equivalent for a SATA disk would be, but chances are it will be easier to track it down with the reference above.

Maciej
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

My laptop harddrive is only a little over a year old and it has a cycle count of 193 Load_Cycle_Count 0x0012 021 021 000 Old_age Always - 795931

it was going up a few counts everytime I ran the smartctl -A command. It quit incrementing after I did the hdparm -B 255 command.

Signature · 3 lines
"They that give up essential liberty to obtain temporary safety, deserve neither liberty nor safety."  (Ben Franklin)

"The course of history shows that as a government grows, liberty decreases."  (Thomas Jefferson)
#5 lore raw
In reply to Maciej W. Rozycki
Quoted 9 lines · Maciej W. Rozycki
Quoted 1 line · Alberto Gonzalez

The problem comes from a very high rate of load/unload cycles of the heads that reaches the 300.000-600.000 limit in 2-3 years (with smartmontools it can checked it with "smartctl -A /dev/sda") . There are reports of HDD dying even earlier for this problem [2]

I use:

# hdparm -B 255 /dev/hda

to get rid of the problem with an ATA disk where I do not care that much about power consumption. I do not know what the equivalent for a SATA disk would be, but chances are it will be easier to track it down with the reference above.

..

The exact same command works with SATA drives.

-ml