PPC: Fix potential NULL dereference
Subsystems (2)
PATCH 1/1 PPC: Fix potential NULL dereference
This patch does fix potential NULL pointer dereference that could take place inside of strcmp() if of_get_property() call failed.
Signed-off-by Cyrill Gorcunov <[email protected]>
---
arch/powerpc/platforms/83xx/usb.c | 8 ++++---- 1 files changed, 4 insertions(+), 4 deletions(-)
arch/powerpc/platforms/83xx/usb.c +4 -4
@@ -130,7 +130,7 @@ int mpc831x_usb_cfg(void)out_be32 (immap +MPC83XX_SCCR_OFFS , temp);/* Configure pin mux for ULPI. There is no pin mux for UTMI */ -if (!strcmp (prop,"ulpi" )) { +if (prop && !strcmp (prop,"ulpi" )) { temp =in_be32 (immap +MPC83XX_SICRL_OFFS ); temp &= ~MPC831X_SICRL_USB_MASK ; temp |=MPC831X_SICRL_USB_ULPI ;
@@ -153,13 +153,13 @@ int mpc831x_usb_cfg(void) usb_regs =ioremap (res.start, res.end - res.start +1 );/* Using on-chip PHY */ -if (!strcmp (prop,"utmi_wide" ) || - !strcmp (prop,"utmi" )) { +if (prop && (!strcmp (prop,"utmi_wide" ) || + !strcmp (prop,"utmi" ))) {/* Set UTMI_PHY_EN, REFSEL to 48MHZ */ out_be32 (usb_regs +FSL_USB2_CONTROL_OFFS ,CONTROL_UTMI_PHY_EN |CONTROL_REFSEL_48MHZ );/* Using external UPLI PHY */ - }else if (!strcmp (prop,"ulpi" )) { + }else if (prop && !strcmp (prop,"ulpi" )) {/* Set PHY_CLK_SEL to ULPI */ temp =CONTROL_PHY_CLK_SEL_ULPI ;#ifdef CONFIG_USB_OTG
Kumar Gala
AppliedQuoted 10 lines · Cyrill Gorcunov
This patch does fix potential NULL pointer dereference that could take place inside of
strcmp()ifof_get_property()call failed.Signed-off-by Cyrill Gorcunov <[email protected]>---
arch/powerpc/platforms/83xx/usb.c | 8 ++++---- 1 files changed, 4 insertions(+), 4 deletions(-)
CC the [email protected] list in the future.
applied.
- k