S3C24XX: Ensure we only configure valid GPIOs

diff -urpN -X linux-2.6.24-rc3/Documentation/dontdiff linux-2.6.24-rc3/drivers/spi/spi_s3c24xx_gpio.c linux-2.6.24-rc3-spigpio1/drivers/spi/spi_s3c24xx_gpio.c
@@ -96,6 +96,7 @@ static void s3c2410_spigpio_chipselect(s
 
 static int s3c2410_spigpio_probe(struct platform_device *dev)
 {
+	struct s3c2410_spigpio_info *info;
 	struct spi_master	*master;
 	struct s3c2410_spigpio  *sp;
 	int ret;

@@ -113,7 +114,7 @@ static int s3c2410_spigpio_probe(struct 
 	platform_set_drvdata(dev, sp);
 
 	/* copy in the plkatform data */
-	sp->info = dev->dev.platform_data;
+	info = sp->info = dev->dev.platform_data;
 
 	/* setup spi bitbang adaptor */
 	sp->bitbang.master = spi_master_get(master);

@@ -124,13 +125,18 @@ static int s3c2410_spigpio_probe(struct 
 	sp->bitbang.txrx_word[SPI_MODE_2] = s3c2410_spigpio_txrx_mode2;
 	sp->bitbang.txrx_word[SPI_MODE_3] = s3c2410_spigpio_txrx_mode3;
 
-	/* set state of spi pins */
-	s3c2410_gpio_setpin(sp->info->pin_clk, 0);
-	s3c2410_gpio_setpin(sp->info->pin_mosi, 0);
-
-	s3c2410_gpio_cfgpin(sp->info->pin_clk, S3C2410_GPIO_OUTPUT);
-	s3c2410_gpio_cfgpin(sp->info->pin_mosi, S3C2410_GPIO_OUTPUT);
-	s3c2410_gpio_cfgpin(sp->info->pin_miso, S3C2410_GPIO_INPUT);
+	/* set state of spi pins, always assume that the clock is
+	 * available, but do check the MOSI and MISO. */
+	s3c2410_gpio_setpin(info->pin_clk, 0);
+	s3c2410_gpio_cfgpin(info->pin_clk, S3C2410_GPIO_OUTPUT);
+
+	if (info->pin_mosi < S3C2410_GPH10) {
+		s3c2410_gpio_setpin(info->pin_mosi, 0);
+		s3c2410_gpio_cfgpin(info->pin_mosi, S3C2410_GPIO_OUTPUT);
+	}
+
+	if (info->pin_miso != S3C2410_GPA0 && info->pin_miso < S3C2410_GPH10)
+		s3c2410_gpio_cfgpin(info->pin_miso, S3C2410_GPIO_INPUT);
 
 	ret = spi_bitbang_start(&sp->bitbang);
 	if (ret)