FSL UPM NAND driver
Subsystems (2)
RFC PATCH 6/7 FSL UPM NAND driver
Oops, forgot to Cc linux-mtd, sorry.
----- Forwarded message from Anton Vorontsov <[email protected]> -----
Date: Mon, 10 Dec 2007 23:49:38 +0300
From: Anton Vorontsov <[email protected]>
To: [email protected]
Subject: [PATCH RFC 6/7] [POWERPC][NAND] FSL UPM NAND driver
Cc: [email protected], [email protected],
[email protected]
List-Id: Linux on PowerPC Developers Mail List <linuxppc-dev.ozlabs.org>
It's using FSL UPM infrastructure. So far only 8 bit accessors are implemented.
Signed-off-by Anton Vorontsov <[email protected]>
--- drivers/mtd/nand/Kconfig | 7 + drivers/mtd/nand/Makefile | 1 + drivers/mtd/nand/fsl_upm.c | 310 ++++++++++++++++++++++++++++++++++++++++++++ 3 files changed, 318 insertions(+), 0 deletions(-) create mode 100644 drivers/mtd/nand/fsl_upm.c
drivers/mtd/nand/Kconfig +7 -0
@@ -306,4 +306,11 @@ config MTD_ALAUDA These two (and possibly other) Alauda-based cardreaders for SmartMedia and xD allow raw flash access. +config MTD_NAND_FSL_UPM + tristate "MTD driver for NAND on Freescale UPM" + depends on MTD_NAND && FSL_UPM + help + Enables support for NAND Flash wired to Freescale processors' + localbus with pre-programmed User-Programmable Machine. + endif # MTD_NAND
drivers/mtd/nand/Makefile +1 -0
@@ -29,5 +29,6 @@ obj-$(CONFIG_MTD_NAND_CM_X270) += cmx270_nand.o obj-$(CONFIG_MTD_NAND_BASLER_EXCITE) += excite_nandflash.o obj-$(CONFIG_MTD_NAND_PLATFORM) += plat_nand.o obj-$(CONFIG_MTD_ALAUDA) += alauda.o +obj-$(CONFIG_MTD_NAND_FSL_UPM) += fsl_upm.o nand-objs := nand_base.o nand_bbt.o
drivers/mtd/nand/fsl_upm.c new file +310 -0
310 lines not on this page · raw message
Signature · 15 lines
1.5.2.2 _______________________________________________ Linuxppc-dev mailing list [email protected] https://ozlabs.org/mailman/listinfo/linuxppc-dev ----- End forwarded message ----- -- Anton Vorontsov email: [email protected] backup email: [email protected] irc://irc.freenode.net/bd2