Skip to contentSkip to conversation

Serial: MPSC - Set baudrate when BRG divider is set.

PATCH New Mark A. Greer 1 participant 1 message Jan 14, 2008

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Serial: MPSC - Set baudrate when BRG divider is set.

From: Mark A. Greer <[email protected]>

The clock to generate the desired baudrate with the MPSC is first divided by the Baud Rate Generator (BRG) and then by the MPSC itself. So, when the BRG divider is changed, the MPSC divider must also be changed to generate the correct baudrate. During MPSC initialization, the BRG divider is changed but the MPSC divider isn't changed until much later. This results in some printk's coming out garbled. To fix that, set the MPSC divider at the same time that the BRG divider is changed.

---
 drivers/serial/mpsc.c |    1 +
 1 file changed, 1 insertion(+)
drivers/serial/mpsc.c +1 -0
index 4d643c9..cb3a919 100644
@@ -612,6 +612,7 @@ static void mpsc_hw_init(struct mpsc_port_info *pi)
 
 	/* No preamble, 16x divider, low-latency, */
 	writel(0x04400400, pi->mpsc_base + MPSC_MMCRH);
+	mpsc_set_baudrate(pi, pi->default_baud);
 
 	if (pi->mirror_regs) {
 		pi->MPSC_CHR_1_m = 0;