8xx : Add fdt support to adder port - resubmit #2

PATCH New Bryan O'Donoghue 1 participant 1 message Feb 17, 2008

Share & tools

Bryan O'Donoghue

author

2008-02-17 22:57 UTC #0 lore raw

PATCH 1/2 8xx : Add fdt support to adder port - resubmit #2

For completeness resubmitting this patch with it's sibling patch - previous patches word-wrapped @ 80 characters. Plus one patch from previous set not necessary ...

Greetings.

Signed-off-by Bryan O'Donoghue <[email protected]>

---

board/adder/adder.c +12 -0

index aa78158..5a2f752 100644
@@ -26,6 +26,9 @@
 
 #include <common.h>
 #include <mpc8xx.h>
+#if defined(CONFIG_OF_LIBFDT)
+	#include <libfdt.h>
+#endif
 
 /*
  * SDRAM is single Samsung K4S643232F-T70   chip (8MB)

@@ -111,3 +114,12 @@ int checkboard( void )
 
 	return 0;
 }
+
+#if defined(CONFIG_OF_BOARD_SETUP)
+void ft_board_setup(void *blob, bd_t *bd)
+{
+	ft_cpu_setup(blob, bd);
+
+}
+#endif
+

include/configs/Adder.h +6 -0

index 4304ecc..7919991 100644
@@ -37,6 +37,8 @@
 
 #define CONFIG_ETHER_ON_FEC1
 #define CONFIG_ETHER_ON_FEC2
+#define CONFIG_HAS_ETH0
+#define CONFIG_HAS_ETH1
 
 #if defined(CONFIG_ETHER_ON_FEC1) || defined(CONFIG_ETHER_ON_FEC2)
 #define CFG_DISCOVER_PHY

@@ -212,4 +214,8 @@
 #define BOOTFLAG_COLD		0x01	/* Normal Power-On: Boot from flash	*/
 #define BOOTFLAG_WARM		0x02	/* Software reboot			*/
 
+/* pass open firmware flat tree */
+#define CONFIG_OF_LIBFDT	1
+#define CONFIG_OF_BOARD_SETUP	1
+
 #endif /* __CONFIG_H */