Skip to contentSkip to conversation

hda/patch_sigmatel.c Panasonic CF-74 speaker output

PATCH In review Kyler Laird 2 participants 2 messages Feb 28, 2008 – Feb 29, 2008 Sound

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 hda/patch_sigmatel.c Panasonic CF-74 speaker output

This patch causes ALSA to send sound to the speakers of a Panasonic CF-74 (Toughbook) instead of just its headphone jack.

--kyler

diff -Naur linux-2.6.24.1/sound/pci/hda/patch_sigmatel.c linux-2.6.24.1-ALSA_CF74/sound/pci/hda/patch_sigmatel.c
--- linux-2.6.24.1/sound/pci/hda/patch_sigmatel.c 2008-02-08
14:55:30.000000000 -0500
+++ linux-2.6.24.1-ALSA_CF74/sound/pci/hda/patch_sigmatel.c

2008-02-11 12:05:11.824064617 -0500
@@ -2467,6 +2467,11 @@
                spec->init = stac9200_core_init;
        spec->mixer = stac9200_mixer;
+       /* Kyler - fix for CF-74 speaker */
+       spec->gpio_mask = 0x00000009;
+       spec->gpio_data = 0x00000000;
+       stac92xx_enable_gpio_mask(codec);
+
        err = stac9200_parse_auto_config(codec);
        if (err < 0) {
                stac92xx_free(codec);
#1 lore raw

At Thu, 28 Feb 2008 09:11:49 -0500,

Quoted 3 lines · Kyler Laird

This patch causes ALSA to send sound to the speakers of a Panasonic CF-74 (Toughbook) instead of just its headphone jack.

Thanks. I think this should be only for specific PCI IDs. Or more better, create a new model to enable it.
Is the PCI SSID of your device 10f7:8338 ?

Your patch cannot be applied to the latest code because of code changes. The patch below adds a quick fix based on your information (for 2.6.25 or later). Could you give it a try?

Takashi

---

sound/pci/hda/patch_sigmatel.c +9 -1
diff -r 54a51b975975 sound/pci/hda/patch_sigmatel.c
@@ -51,6 +51,7 @@ enum {
 	STAC_9200_DELL_M26,
 	STAC_9200_DELL_M27,
 	STAC_9200_GATEWAY,
+	STAC_9200_PANASONIC,
 	STAC_9200_MODELS
 };
 
@@ -1083,6 +1084,7 @@ static unsigned int *stac9200_brd_tbl[ST
 	[STAC_9200_DELL_M25] = dell9200_m25_pin_configs,
 	[STAC_9200_DELL_M26] = dell9200_m26_pin_configs,
 	[STAC_9200_DELL_M27] = dell9200_m27_pin_configs,
+	[STAC_9200_PANASONIC] = ref9200_pin_configs,
 };
 
 static const char *stac9200_models[STAC_9200_MODELS] = {
@@ -1099,6 +1101,7 @@ static const char *stac9200_models[STAC_
 	[STAC_9200_DELL_M26] = "dell-m26",
 	[STAC_9200_DELL_M27] = "dell-m27",
 	[STAC_9200_GATEWAY] = "gateway",
+	[STAC_9200_PANASONIC] = "panasonic",
 };
 
 static struct snd_pci_quirk stac9200_cfg_tbl[] = {
@@ -1165,7 +1168,7 @@ static struct snd_pci_quirk stac9200_cfg
 	SND_PCI_QUIRK(PCI_VENDOR_ID_DELL, 0x01f6,
 		      "unknown Dell", STAC_9200_DELL_M26),
 	/* Panasonic */
-	SND_PCI_QUIRK(0x10f7, 0x8338, "Panasonic CF-74", STAC_REF),
+	SND_PCI_QUIRK(0x10f7, 0x8338, "Panasonic CF-74", STAC_9200_PANASONIC),
 	/* Gateway machines needs EAPD to be set on resume */
 	SND_PCI_QUIRK(0x107b, 0x0205, "Gateway S-7110M", STAC_9200_GATEWAY),
 	SND_PCI_QUIRK(0x107b, 0x0317, "Gateway MT3423, MX341*",
@@ -3263,6 +3266,11 @@ static int patch_stac9200(struct hda_cod
 	else
 		spec->init = stac9200_core_init;
 	spec->mixer = stac9200_mixer;
+
+	if (spec->board_config == STAC_9200_PANASONIC) {
+		spec->gpio_mask = spec->gpio_dir = 0x09;
+		spec->gpio_data = 0x00;
+	}
 
 	err = stac9200_parse_auto_config(codec);
 	if (err < 0) {