sound/pci: coding style fixes: sound/pci/c*
Subsystems (3)
PATCH 6/24 sound/pci: coding style fixes: sound/pci/c*
- <asm/io.h> -> <linux/io.h>
- remove trailing whitespaces
- convert comments
Only compile tested.
Signed-off-by Alexander Beregalov <[email protected]>
---
sound/pci/bt87x.c | 4 +- sound/pci/cmipci.c | 80 +++++++++++++++--------------- sound/pci/cs4281.c | 82 ++++++++++++++++---------------- sound/pci/cs5530.c | 8 ++-- sound/pci/cs5535audio/cs5535audio.c | 8 ++-- sound/pci/cs5535audio/cs5535audio_pm.c | 12 ++-- 6 files changed, 97 insertions(+), 97 deletions(-)
sound/pci/bt87x.c +2 -2
@@ -27,7 +27,7 @@#include <linux/slab.h> #include <linux/moduleparam.h> #include <linux/bitops.h> -#include <asm/io.h> +#include <linux/io.h> #include <sound/core.h> #include <sound/pcm.h> #include <sound/pcm_params.h>
@@ -603,7 +603,7 @@ static int snd_bt87x_capture_boost_get(struct snd_kcontrol *kcontrol, {struct snd_bt87x *chip =snd_kcontrol_chip (kcontrol); - value->value.integer.value[0 ] = !! (chip->reg_control &CTL_A_G2X ); + value->value.integer.value[0 ] = !!(chip->reg_control &CTL_A_G2X );return 0 ; }
sound/pci/cmipci.c +40 -40
315 lines not on this page · raw message
sound/pci/cs4281.c +41 -41
276 lines not on this page · raw message
sound/pci/cs5530.c +4 -4
@@ -10,8 +10,8 @@* simultaneously play back audio at 16bit 44100kHz, the device actually plays * back in the same format in which it is capturing. By forcing the chip to * always play/capture in 16/44100, we can let alsa-lib convert the samples and -* that way we can hack up some full duplex audio. -* +* that way we can hack up some full duplex audio. +* * XpressAudio(tm) is used on the Cyrix MediaGX (now NatSemi Geode) systems. * The older version (VSA1) provides fairly good soundblaster emulation * although there are a couple of bugs: large DMA buffers break record,
@@ -126,7 +126,7 @@ static int __devinit snd_cs5530_create(struct snd_card *card, err =pci_request_regions (pci,"CS5530" );if (err <0 ) { -kfree (chip); +kfree (chip);pci_disable_device (pci);return err; }
@@ -207,7 +207,7 @@ static int __devinit snd_cs5530_create(struct snd_card *card,return -ENODEV ; } -printk (KERN_INFO "CS5530: IRQ: %d DMA8: %d DMA16: %d\n" , irq, dma8, +printk (KERN_INFO "CS5530: IRQ: %d DMA8: %d DMA16: %d\n" , irq, dma8, dma16); err = snd_sbdsp_create(card, sb_base, irq, snd_sb16dsp_interrupt, dma8,
sound/pci/cs5535audio/cs5535audio.c +4 -4
@@ -27,7 +27,7 @@#include <linux/pci.h> #include <linux/slab.h> #include <linux/moduleparam.h> -#include <asm/io.h> +#include <linux/io.h> #include <sound/core.h> #include <sound/control.h> #include <sound/pcm.h>
@@ -46,9 +46,9 @@ MODULE_PARM_DESC(ac97_quirk, "AC'97 board specific workarounds.");static struct ac97_quirk ac97_quirks[]__devinitdata = { #if 0 /* Not yet confirmed if all 5536 boards are HP only */ { - .subvendor =PCI_VENDOR_ID_AMD , - .subdevice =PCI_DEVICE_ID_AMD_CS5536_AUDIO , - .name ="AMD RDK" , + .subvendor =PCI_VENDOR_ID_AMD , + .subdevice =PCI_DEVICE_ID_AMD_CS5536_AUDIO , + .name ="AMD RDK" , .type =AC97_TUNE_HP_ONLY }, #endif
sound/pci/cs5535audio/cs5535audio_pm.c +6 -6
@@ -32,18 +32,18 @@static void snd_cs5535audio_stop_hardware (struct cs5535audio *cs5535au) { -/* +/* we depend on snd_ac97_suspend to tell the AC97 codec to shutdown. the amd spec suggests that the LNK_SHUTDOWN be done at the same time that the codec power-down is issued. instead, -we do it just after rather than at the same +we do it just after rather than at the same time. excluding codec specific build_ops->suspend ac97 powerdown hits: -0x8000 EAPD -0x4000 Headphone amplifier -0x0300 ADC & DAC -0x0400 Analog Mixer powerdown (Vref on) +0x8000 EAPD +0x4000 Headphone amplifier +0x0300 ADC & DAC +0x0400 Analog Mixer powerdown (Vref on) I am not sure if this is the best that we can do. The remainder to be investigated are: - analog mixer (vref off) 0x0800