: sparc32: Use PROM device probing for sun4c timers.
David Miller
maintainerPATCH 10/13 : sparc32: Use PROM device probing for sun4c timers.
sparc32: Use PROM device probing for sun4c timers.
Signed-off-by David S. Miller <[email protected]>
--- arch/sparc/include/asm/timer_32.h | 24 --------------- arch/sparc/kernel/sun4c_irq.c | 59 ++++++++++++++++++++++++------------ 2 files changed, 39 insertions(+), 44 deletions(-)
arch/sparc/include/asm/timer_32.h +0 -24
@@ -11,30 +11,6 @@#include <asm/system.h> /* For SUN4M_NCPUS */ #include <asm/btfixup.h> -/* Timer structures. The interrupt timer has two properties which -* are the counter (which is handled in do_timer in sched.c) and the limit. -* This limit is where the timer's counter 'wraps' around. Oddly enough, -* the sun4c timer when it hits the limit wraps back to 1 and not zero -* thus when calculating the value at which it will fire a microsecond you -* must adjust by one. Thanks SUN for designing such great hardware ;( -*/ - -/* Note that I am only going to use the timer that interrupts at -* Sparc IRQ 10. There is another one available that can fire at -* IRQ 14. Currently it is left untouched, we keep the PROM's limit -* register value and let the prom take these interrupts. This allows -* L1-A to work. -*/ - -struct sun4c_timer_info { - __volatile__ unsigned int cur_count10; - __volatile__ unsigned int timer_limit10; - __volatile__ unsigned int cur_count14; - __volatile__ unsigned int timer_limit14; -}; - -#define SUN_TIMER_PHYSADDR 0xf3000000 - extern __volatile__ unsigned int *master_l10_counter; extern __volatile__ unsigned int *master_l10_limit;
arch/sparc/kernel/sun4c_irq.c +39 -20
87 lines not on this page · raw message
Signature · 1 line
1.5.6.5