iwl3945: remove obsolete irq handling

3945 hardware does not emit the interrupts CSR_INT_BIT_RF_KILL (rfkill toggled) and CSR_INT_BIT_CT_KILL (adapter too hot). Hence this part of code can be removed since iwl3945_irq_tasklet does not handle 4965 hw at all.

Signed-off-by Helmut Schaa <[email protected]>

---

drivers/net/wireless/iwlwifi/iwl3945-base.c +0 -30

index 490bc4a..b32b507 100644
@@ -4321,35 +4321,6 @@ static void iwl3945_irq_tasklet(struct iwl3945_priv *priv)
 	/* Safely ignore these bits for debug checks below */
 	inta &= ~(CSR_INT_BIT_SCD | CSR_INT_BIT_ALIVE);
 
-	/* HW RF KILL switch toggled (4965 only) */
-	if (inta & CSR_INT_BIT_RF_KILL) {
-		int hw_rf_kill = 0;
-		if (!(iwl3945_read32(priv, CSR_GP_CNTRL) &
-				CSR_GP_CNTRL_REG_FLAG_HW_RF_KILL_SW))
-			hw_rf_kill = 1;
-
-		IWL_DEBUG(IWL_DL_INFO | IWL_DL_RF_KILL | IWL_DL_ISR,
-				"RF_KILL bit toggled to %s.\n",
-				hw_rf_kill ? "disable radio" : "enable radio");
-
-		/* Queue restart only if RF_KILL switch was set to "kill"
-		 *   when we loaded driver, and is now set to "enable".
-		 * After we're Alive, RF_KILL gets handled by
-		 *   iwl3945_rx_card_state_notif() */
-		if (!hw_rf_kill && !test_bit(STATUS_ALIVE, &priv->status)) {
-			clear_bit(STATUS_RF_KILL_HW, &priv->status);
-			queue_work(priv->workqueue, &priv->restart);
-		}
-
-		handled |= CSR_INT_BIT_RF_KILL;
-	}
-
-	/* Chip got too hot and stopped itself (4965 only) */
-	if (inta & CSR_INT_BIT_CT_KILL) {
-		IWL_ERROR("Microcode CT kill error detected.\n");
-		handled |= CSR_INT_BIT_CT_KILL;
-	}
-
 	/* Error detected by uCode */
 	if (inta & CSR_INT_BIT_SW_ERR) {
 		IWL_ERROR("Microcode SW error detected.  Restarting 0x%X.\n",
--

To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html