r6040: check PHY status when bringing interface up
Subsystems (2)
PATCH 2/4 r6040: check PHY status when bringing interface up
From: Florian Fainelli <[email protected]>
Subject: [PATCH 2/4] r6040: check PHY status when bringing interface up
This patch makes the driver properly initialize the PHY status if not correctly set by the bootloader/BIOS. It prevents some boards to bring up the link on boot.
Signed-off-by Florian Fainelli <[email protected]>
---
drivers/net/r6040.c +4 -0
@@ -1107,6 +1107,10 @@ static int __devinit r6040_init_one(struct pci_dev *pdev, err = -EIO ; goto err_out_free_res; } +/* If PHY status change register is still set to zero it means the +* bootloader didn't initialize it */ +if (ioread16 (ioaddr +PHY_CC ) ==0 ) +iowrite16 (0x9f07 , ioaddr +PHY_CC );/* Init system & device */ lp->base = ioaddr;
From: Florian Fainelli <[email protected]>
Date: Wed, 7 Jan 2009 17:40:37 +0100
Quoted 7 lines
r6040: check PHY status when bringing interface up
This patch makes the driver properly initialize the PHY status if not correctly set by the bootloader/BIOS. It prevents some boards to bring up the link on boot.
Signed-off-by Florian Fainelli <[email protected]>
Applied.