atmel_spi: Fix handling of chipselect after SPI transfer
Subsystems (2)
PATCH 1/1 atmel_spi: Fix handling of chipselect after SPI transfer
According to include/linux/spi/spi.h chipselect should stay active after a SPI transfer or after a SPI message unless modified by spi_transfer.cs_change != 0.
The current atmel driver passes this field to atmel_spi_msg_done as a parameter with oppositional meaning: "cs_change" -> "stay" (see atmel_spi_interrupt).
This patch fixes this behavoir by adapting the called function and its callers. IMHO this solution is better than an one line fix of inverting the function's argument as the meaning of the field remains throughout the hole stack.
Signed-off-by Michael Heimpold <[email protected]>
--- drivers/spi/atmel_spi.c | 6 +++--- 1 files changed, 3 insertions(+), 3 deletions(-)
drivers/spi/atmel_spi.c +3 -3
@@ -351,9 +351,9 @@ static void atmel_spi_dma_unmap_xfer(struct spi_master *master,static void atmel_spi_msg_done (struct spi_master *master,struct atmel_spi *as, -struct spi_message *msg,int status,int stay) +struct spi_message *msg,int status,int cs_change) { -if (!stay || status <0 ) +if (cs_change || status <0 )cs_deactivate (as, msg->spi);else as->stay = msg->spi;
@@ -448,7 +448,7 @@ atmel_spi_interrupt(int irq, void *dev_id)/* Clear any overrun happening while cleaning up */ spi_readl (as,SR ); -atmel_spi_msg_done (master, as, msg, -EIO ,0 ); +atmel_spi_msg_done (master, as, msg, -EIO ,1 ); }else if (pending & (SPI_BIT (RXBUFF ) |SPI_BIT (ENDRX ))) { ret =IRQ_HANDLED ;
Signature · 1 line
1.5.4.3