Skip to contentSkip to conversation

U-BOOT MPC8560 based board : No prints after relocation

U-Boot Deepak Gaur 2 participants 2 messages Feb 17, 2009

lore
Share & tools
lore
#0 lore raw

Hello

I am porting U-BOOT on an MPC8560ADS like custom board with 1GB DDR SDRAM. My minicom port is connected to SCC1 of MPC8560 on 9600 8N1 baud rate. After relocation of U-BOOT in RAM
prints stops coming

My boot flash 0xfff80000 - 0xffffffff

TEXT_BASE = 0xfff80000

Using emulator I took dump of SDRAM. U-BOOT code is there.

Any idea why prints are not coming

with regards,

Deepak Gaur

#1 lore raw

Dear "Deepak Gaur",

Quoted 5 lines · In message <[email protected]> you wrote:

I am porting U-BOOT on an MPC8560ADS like custom board with 1GB DDR SDRAM. My minicom port is connected to SCC1 of MPC8560 on 9600 8N1 baud rate. After relocation of U-BOOT in RAM
prints stops coming

See U-Boot FAQ "U-Boot crashes after relocation to RAM"

Best regards,

Wolfgang Denk

Signature · 5 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"'Tis true, 'tis pity, and pity 'tis 'tis true."
    - Poloniouius, in Willie the Shake's _Hamlet, Prince of Darkness_