Skip to contentSkip to conversation

Fails to boot in Hercules if HVC_IUCV is set

BUG,2.6.29-rc7 Hendrik Brueckner 1 participant 1 message Mar 9, 2009 1 message not in the archive s390

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 5 lines · Frans Pop
Quoted 4 lines · Frans Pop
Quoted 4 lines

Initially I had CONFIG_HVC_IUCV set to y, and with that the boot stopped after:
hvc_iucv: The z/VM IUCV HVC device driver cannot be used without z/VM

Quoted 7 lines
Quoted 3 lines
Quoted 3 lines

Looks like the system got into a loop with one processor at 100%.

After disabling the option the boot was successful.

As I can't be sure whether the boot failure with HVC_IUCV is or isn't a side effect of the hrtimer issue mentioned in my previous mail [1], I suggest we leave this until the hrtimer issue has been resolved. From what I've seen during the bisection I suspect it is just a side-effect.

If the HVC_IUCV driver writes the message "...cannot be used without z/VM", the driver initialization stops and returns with ENODEV.

Best regards
Hendrik

Signature · 5 lines
IBM Deutschland Research & Development GmbH
Vorsitzender des Aufsichtsrats: Martin Jetter
Geschaeftsfuehrung: Erich Baier
Sitz der Gesellschaft: Boeblingen
Registergericht: Amtsgericht Stuttgart, HRB 243294