Skip to contentSkip to conversation

Irritating USB Flash Memory LED behaviour (usb_storage related?)

DISCUSSION Claus Fischer 1 participant 1 message Mar 25, 2009

lore
Share & tools
lore
#0 lore raw

Summary: Some new USB memory sticks will not stop blinking the LED.
Behaviour varies across distributions and OS's. Any helpful hints appreciated.

On a system that we use for mass erasure of USB sticks (64 sticks), based on Debian with automatical udev-handling of USB sticks disabled, we have a problem with a batch of new USB sticks: They will continue blinking for as long as they are plugged in, independent of data access.

The sticks however stop blinking (as they should) on a SuSE based desktop system with the usual KDE software. They also stop blinking when attached to a Windows system.

Good behaviour:
***************

Previously, (good) USB sticks would behave like this:
- blink while the usb_storage module identifies them and maps them to an SCSI device

 -  then stop blinking
 -  blink again while being formatted via our script
 -  stop blinking after being unmounted

Together with a visual program display, the blinking LED has always been a good indicator for operating personnel of the stick's status.

Bad behaviour:
**************
The new sticks will start blinking when the usb_storage module kicks in use, and continue blinking throughout idle phases, mounts, writes, umounts etc.; an eject command will change the blinking to a permanently lighted LED, but it will never go off.

I'm at a loss looking for the reason of the continued blinking, and how to get rid of it (it's a large batch of sticks, and returning them is out of the question).

Possible causes:
- Kernel
But: the "good" SuSE kernel 2.6.25 is between "bad" Debian 2.6.16 and "bad" Debian 2.6.26.
Also, old USB sticks work fine with each machine.
- Bad USB controller
The new batch of sticks uses a different internal USB controller from old batches.
But: Windows and SuSE work fine.
- Interaction of KDE components with the USB stick
that is missing on our batch formatting system.
But: Why do old sticks work fine without such interaction?

Questions:
- I always thought that USB stick LEDs cannot be controlled by the operating system. They just indicates "write accesses". Is that correct?
- If USB stick leds are not OS-accessible, why do the new sticks behave differently on different systems?
- If USB stick leds are OS-accessible, has there been any change in policy of kernel/modules that leave them blinking?
- Can anyone point me to information how SuSE/KDE control the blinking light, and how I can (write code to) let the LED react similarly on our Debian-based batch system?
[ For various reasons beyond the scope of this mail,
automatically mounting the sticks is out of the question. ]

Any helpful hints, pointers to knowledge/information etc. are greatly appreciated.

Best regards,

Claus

Signature · 2 lines
Claus Fischer <[email protected]>
http://www.clausfischer.com/