ar9170usb: reset device on resume
PATCH 1/1 ar9170usb: reset device on resume
This patch takes care of an outstanding comment in "[PATCH] ar9170usb: fix hang on resume" commit message.
Quoted 5 lines
However, the device does not accept the firmware on resume. and it will exit with:
Quoted 2 lines
firmware part 1 upload failed (-71).
device is in a bad state. please reconnect it!
---
Johannes,
does this two-liner breathe life into the device after resume?
Regards,
Chr
---
drivers/net/wireless/ath/ar9170/usb.c +2 -0
@@ -689,6 +689,7 @@ static int ar9170_usb_probe(struct usb_interface *intf, aru->common.exec_cmd = ar9170_usb_exec_cmd; aru->common.callback_cmd = ar9170_usb_callback_cmd; + udev->reset_resume =1 ; err =ar9170_usb_reset (aru);if (err) goto err_freehw;
@@ -805,6 +806,7 @@ static struct usb_driver ar9170_driver = {#ifdef CONFIG_PM .suspend = ar9170_suspend, .resume = ar9170_resume, + .reset_resume = ar9170_resume,#endif /* CONFIG_PM */ };
Quoted 9 lines · Christian Lamparter
This patch takes care of an outstanding comment in "[PATCH] ar9170usb: fix hang on resume" commit message.
Quoted 5 lines
However, the device does not accept the firmware on resume. and it will exit with:
Quoted 2 lines
firmware part 1 upload failed (-71).
device is in a bad state. please reconnect it!
Quoted 6 lines
Reported-by Johannes Berg <[email protected]>Signed-off-by Christian Lamparter <[email protected]>---
Johannes,does this two-liner breathe life into the device after resume?
Yes, this helps.
johannes