Skip to contentSkip to conversation

sh: smsc911x support for the rsk7203 board

PATCH In review Magnus Damm 2 participants 2 messages Apr 28, 2009 SuperH

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 sh: smsc911x support for the rsk7203 board

From: Magnus Damm <[email protected]>

This patch adds support for the LAN9118 ethernet on rsk7203.

The LAN9118 controller is hooked up using a 16-bit data bus, but the rsk7203 board does not swap the byte lanes as needed between the sh7203 processor and the the ethernet controller.

In the processor the CS memory window is configured in 16-bit mode but the smsc911x driver is told to do 32-bit accesses to improve performance. The SMSC911X_SWAP_FIFO flag is used to tell the driver to do software byte swapping of fifo data.

---

Needs "smsc911x: add fifo byteswap support V2".

 arch/sh/boards/mach-rsk/devices-rsk7203.c |    8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)
arch/sh/boards/mach-rsk/devices-rsk7203.c +6 -2
@@ -26,13 +26,13 @@ static struct smsc911x_platform_config s
 	.phy_interface	= PHY_INTERFACE_MODE_MII,
 	.irq_polarity	= SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
 	.irq_type	= SMSC911X_IRQ_TYPE_OPEN_DRAIN,
-	.flags		= SMSC911X_USE_16BIT,
+	.flags		= SMSC911X_USE_32BIT | SMSC911X_SWAP_FIFO,
 };
 
 static struct resource smsc911x_resources[] = {
 	[0] = {
 		.start		= 0x24000000,
-		.end		= 0x24000000 + 0x100,
+		.end		= 0x240000ff,
 		.flags		= IORESOURCE_MEM,
 	},
 	[1] = {
@@ -99,6 +99,10 @@ static int __init rsk7203_devices_setup(
 	gpio_request(GPIO_FN_TXD0, NULL);
 	gpio_request(GPIO_FN_RXD0, NULL);
 
+	/* Setup LAN9118: CS1 in 16-bit Big Endian Mode, IRQ0 at Port B */
+	ctrl_outl(0x36db0400, 0xfffc0008); /* CS1BCR */
+	gpio_request(GPIO_FN_IRQ0_PB, NULL);
+
 	return platform_add_devices(rsk7203_devices,
 				    ARRAY_SIZE(rsk7203_devices));
 }
Acked-by on v1 1/1
#1 lore raw

Magnus Damm <[email protected]> wrote on 28/04/2009 09:02:13:

Quoted 8 lines

From: Magnus Damm <[email protected]>

This patch adds support for the LAN9118 ethernet on rsk7203.

The LAN9118 controller is hooked up using a 16-bit data bus, but the rsk7203 board does not swap the byte lanes as needed between the sh7203 processor and the the ethernet controller.

Quoted 7 lines

In the processor the CS memory window is configured in 16-bit mode but the smsc911x driver is told to do 32-bit accesses to improve performance. The SMSC911X_SWAP_FIFO flag is used to tell the driver to do software byte swapping of fifo data.

---