Skip to contentSkip to conversation

ARM: OMAP2/3: Add generic smc91x support when connected to GPMC

PATCH Tony Lindgren 1 participant 1 message May 16, 2009

Subsystems (5)
lore
Share & tools
lore

Tony Lindgren

author maintainer
#0 lore raw

Hi all,

Here's an patch for generic gpmc-smc91x support.

The patch now uses better timings from the smc91x data sheet thanks to Paul Walmsley, but the SDP board timings remain a bit of a mystery..

So the patch currently does not change the timings for 2430sdp and 3430sdp as they seem to be connected in the muxed mode, and possibly through the FPGA too. Uboot timings are used instead.

Does anybody here from TI know about calculating the timings for the SDP boards? And if the smc91x is wired through the FPGA instead of level shifters?

The patch could be improved further later on with better timings to account for the level shifter latencies as pointed out by Paul.

Regards,

Tony

Quoted 1 line

From bd4425c7e87449c01849e60bd72a7a62a650bbcc Mon Sep 17 00:00:00 2001

From: Tony Lindgren <[email protected]>
Date: Fri, 15 May 2009 08:05:03 -0700
Subject: [PATCH] ARM: OMAP2/3: Add generic smc91x support when connected to GPMC

Convert the board-rx51 smc91x code to be generic and make the boards to use it. This allows future recalculation of the timings when the source clock gets scaled.

Also correct the rx51 interrupt to be IORESOURCE_IRQ_HIGHLEVEL.

Thanks to Paul Walmsley <[email protected]> for better GPMC timing calculations.

arch/arm/mach-omap2/Makefile +3 -0
index 11f7f66..e4f6f61 100644
@@ -61,3 +61,6 @@ endif
 
 onenand-$(CONFIG_MTD_ONENAND_OMAP2)	:= gpmc-onenand.o
 obj-y					+= $(onenand-m) $(onenand-y)
+
+smc91x-$(CONFIG_SMC91X)			:= gpmc-smc91x.o
+obj-y					+= $(smc91x-m) $(smc91x-y)
arch/arm/mach-omap2/board-2430sdp.c +18 -83

138 lines not on this page · raw message

arch/arm/mach-omap2/board-3430sdp.c +22 -56

121 lines not on this page · raw message

arch/arm/mach-omap2/board-rx51-peripherals.c +23 -117

164 lines not on this page · raw message

arch/arm/mach-omap2/gpmc-smc91x.c new file +189 -0

189 lines not on this page · raw message

arch/arm/plat-omap/include/mach/gpmc-smc91x.h new file +46 -0

46 lines not on this page · raw message