serial: enable higher baud rates for 16c95x
This patch has been around (and in Fedora) for 4 years.
Previous discussion around this patch:
http://marc.theaimsgroup.com/?l=linux-kernel&m=112687270832687&w=2
https://bugzilla.redhat.com/bugzilla/show_bug.cgi?id=126403
http://lkml.org/lkml/2006/8/2/208
The objection seemed to be summarised as "it might break something else". In the four years it's been in Fedora, I don't recall seeing a single serial bug report that was related.
From: Mathias Adam <[email protected]>
Signed-off-by Dave Jones <[email protected]>
drivers/serial/8250.c +27 -2
@@ -7,6 +7,9 @@* * Copyright (C) 2001 Russell King. * +* 2005/09/16: Enabled higher baud rates for 16C95x. +* (Mathias Adam <[email protected]>) +* * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by * the Free Software Foundation; either version 2 of the License, or
@@ -1652,6 +1655,14 @@else if ((port->flags &UPF_MAGIC_MULTIPLIER ) && baud == (port->uartclk/8 )) quot =0x8002 ; +/* +* For 16C950s UART_TCR is used in combination with divisor==1 +* to achieve baud rates up to baud_base*4. +*/ +else if ((port->type ==PORT_16C950 ) && + baud > (port->uartclk/16 )) + quot =1 ; +else quot =uart_get_divisor (port, baud);
@@ -1665,7 +1676,7 @@struct uart_8250_port *up = (struct uart_8250_port *)port;unsigned char cval, fcr =0 ;unsigned long flags; -unsigned int baud, quot; +unsigned int baud, quot, max_baud;switch (termios->c_cflag &CSIZE ) {case CS5 :
@@ -2034,7 +2034,8 @@ serial8250_set_termios(struct uart_port/* * Ask the core to calculate the divisor for us. */ - baud =uart_get_baud_rate (port, termios, old,0 , port->uartclk/16 ); + max_baud = (up->port.type ==PORT_16C950 ? port->uartclk/4 : port->uartclk/16 ); + baud =uart_get_baud_rate (port, termios, old,0 , max_baud); quot =serial8250_get_divisor (port, baud);/*
@@ -1733,6 +1745,19 @@*/ spin_lock_irqsave (&up->port.lock, flags); +/* +* 16C950 supports additional prescaler ratios between 1:16 and 1:4 +* thus increasing max baud rate to uartclk/4. +*/ +if (up->port.type ==PORT_16C950 ) { +if (baud == port->uartclk/4 ) +serial_icr_write (up,UART_TCR ,0x4 ); +else if (baud == port->uartclk/8 ) +serial_icr_write (up,UART_TCR ,0x8 ); +else +serial_icr_write (up,UART_TCR ,0 ); + } +/* * Update the per-port timeout. */