unable to see jffs2 partition
Hi all,
I've been trying unsuccessfully to see my jffs2 partition I've created by the mtdtools under linux. If their a known issue with this? Is their a size limit? Maybe the way it's created? I do not have a problem with this partition from linux but also never looked at it from the u-boot.
I can change partitions but "ls" shows partition is empty when their are files.
...
#define CONFIG_CMD_JFFS2 1 /** JFFS2 Support */
#define CONFIG_CMD_MTDPARTS 1
#define CONFIG_JFFS2_CMDLINE 1
#undef CONFIG_CMD_FLASH
#define CONFIG_JFFS2_NAND 1
#define CONFIG_JFFS2_DEV "nand0"
#define CONFIG_JFFS2_PART_OFFSET 0x0
#define CONFIG_JFFS2_PART_SIZE 0x5000000
#define MTDPARTS_DEFAULT "mtdparts=nand:80M(IMGS),-(DATA)"
#define MTDIDS_DEFAULT "nand0=nand"
...
Thanks,
E!
Quoted 21 lines · E Robertson
Hi all,
I've been trying unsuccessfully to see my jffs2 partition I've created by the mtdtools under linux. If their a known issue with this? Is their a size limit? Maybe the way it's created? I do not have a problem with this partition from linux but also never looked at it from the u-boot. I can change partitions but "ls" shows partition is empty when their are files....
#defineCONFIG_CMD_JFFS21 /** JFFS2 Support */
#defineCONFIG_CMD_MTDPARTS1
#defineCONFIG_JFFS2_CMDLINE1
#undefCONFIG_CMD_FLASH
#defineCONFIG_JFFS2_NAND1
#defineCONFIG_JFFS2_DEV"nand0"
#defineCONFIG_JFFS2_PART_OFFSET0x0
#defineCONFIG_JFFS2_PART_SIZE0x5000000
#defineMTDPARTS_DEFAULT"mtdparts=nand:80M(IMGS),-(DATA)"
#defineMTDIDS_DEFAULT"nand0=nand"
...
Quoted 2 lines
Thanks,
E!
Forget to add I'm using 03.09 git source on SAM9263 SoC.