HP Jornada flashrom doesnt boot
Greetings,
Im at the state where it compiles nicely (thanks wolfgang!) but doesnt do anything. I am working with an old blob code that I know works and tried to
move all the data from there into u-boot. Currently I get no output
at all on serial and the handheld itself makes a small humming noise.
ANY ideas would be greatly appreciated. According to blob it should use the serial3, do I need to initialize it somehow or is it handled already?
The only value I couldnt extract from blob was the MDREFR value, currenyl Im using the value used by assabet. How can I calculate this?
I know that the memory/flash size settings arent correct. For example its set for 32MB when Im using 128MB but thought that it wouldnt matter much initially?
As Ive said, any suggestions would help alot since Im basicly stuck.
Best wishes
Kristoffer
MAKEALL +1 -0
@@ -485,6 +485,7 @@ LIST_SA=" \ gcplus \ lart \ shannon \ + jornada \ " #########################################################################
Makefile +3 -0
@@ -2716,6 +2716,9 @@ lart_config : unconfig shannon_config : unconfig @$(MKCONFIG) $(@:_config=) arm sa1100 shannon +jornada_config : unconfig + @$(MKCONFIG) $(@:_config=) arm sa1100 jornada + ######################################################################### ## ARM92xT Systems #########################################################################
board/jornada/Makefile new file +53 -0
53 lines not on this page · raw message
board/jornada/config.mk new file +7 -0
@@ -0,0 +1,7 @@ +# +# SA-1110 based HP Jornada board +# +# The Intel Jornada 1 bank of 32 MiB SDRAM +# + +TEXT_BASE = 0xc1f00000
board/jornada/jornada.c new file +66 -0
66 lines not on this page · raw message
board/jornada/setup.S new file +164 -0
164 lines not on this page · raw message
board/jornada/u-boot.lds new file +58 -0
58 lines not on this page · raw message
include/configs/jornada.h new file +151 -0
151 lines not on this page · raw message
Signature · 1 line
Kristoffer Ericson <[email protected]>