Skip to contentSkip to conversation

TI Calypso Driver

DISCUSSION Denis Kenzior 2 participants 4 messages Sep 4, 2009 – Sep 11, 2009

lore
Share & tools
lore
#0 lore raw

Hi guys,

I submitted a preliminary driver for TI Calypso based devices (e.g. OpenMoko Freerunner). It works well enough that I can power up / down the modem, register to the network, scan operators, etc. Voice calls & SMS features should also work.

Simply insert the following lines into modem.conf to enable this device:
[calypso]
Driver=calypso
Device=/dev/ttySAC0

Regards,
-Denis

#1 lore raw

Hi Denis,

Quoted 4 lines

Simply insert the following lines into modem.conf to enable this device:
[calypso]
Driver=calypso
Device=/dev/ttySAC0

thanks for the driver. I tried to use it via network, but I dont see dbus object pathes for the device.

I use pty [1] on my workstation and netcat on the freerunner to forward the at-commands. I can use /dev/pts/3 with cu to send at commands, but ofono doesnt show the object path for the modem.

Best regards.

[1]http://svn.openmoko.org/trunk/src/host/qemu-neo1973/pty.c

#3 lore raw
In reply to Denis Kenzior

Hi Denis,

Quoted 4 lines

Simply insert the following lines into modem.conf to enable this device:
[calypso]
Driver=calypso
Device=/dev/ttySAC0

thanks for the driver. I tried to use it via network, but I dont see dbus object pathes for the device.

I use pty [1] on my workstation and netcat on the freerunner to forward the at-commands. I can use /dev/pts/3 with cu to send at commands, but ofono doesnt show the object path for the modem.

Best regards.

[1]http://svn.openmoko.org/trunk/src/host/qemu-neo1973/pty.c

#2 lore raw
In reply to [email protected]

Hi,

Quoted 9 lines

Hi Denis,

Quoted 4 lines

Simply insert the following lines into modem.conf to enable this device:
[calypso]
Driver=calypso
Device=/dev/ttySAC0

thanks for the driver. I tried to use it via network, but I dont see dbus object pathes for the device.

Make sure that your modem.conf is properly configured and resides int he proper sysconfig directory.

Also, the calypso modem driver assumes it is running natively on the Freerunner. If you want to use this over the network, you can use the phonesim driver. This one can be connected to any TCP socket exporting the AT command modem.

[calypsonet]
Driver=phonesim
Address=192.168.0.202 # or whatever your GTA0x IP is Port=2000 # or whatever GTA0X port is Modem=calypso

Then setup netcat or ser2net to forward he raw tty over the network.

Regards,
-Denis