kbuild: fail build if recordmcount.pl fails
PATCH 17/18 kbuild: fail build if recordmcount.pl fails
From: Andi Kleen <[email protected]>
When this script fails the build should fail too. Otherwise there are mysterious build failures later.
Signed-off-by Andi Kleen <[email protected]>
Cc Sam Ravnborg <[email protected]>
Signed-off-by Andrew Morton <[email protected]>
---
scripts/Makefile.build | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
scripts/Makefile.build renamed from scripts/Makefile.build~kbuild-fail-build-if-recordmcountpl-fails +1 -1
@@ -206,7 +206,7 @@ cmd_modversions = \ endif ifdef CONFIG_FTRACE_MCOUNT_RECORD -cmd_record_mcount = perl $(srctree)/scripts/recordmcount.pl "$(ARCH)" \ +cmd_record_mcount = set -e ; perl $(srctree)/scripts/recordmcount.pl "$(ARCH)" \ "$(if $(CONFIG_64BIT),64,32)" \ "$(OBJDUMP)" "$(OBJCOPY)" "$(CC)" "$(LD)" "$(NM)" "$(RM)" "$(MV)" \ "$(if $(part-of-module),1,0)" "$(@)";
_