mpt2sas: Retrieve the ioc facts prior to putting the controller into READY state
PATCH 13/20 mpt2sas: Retrieve the ioc facts prior to putting the controller into READY state
The driver needs to retrieve the ioc facts prior to putting the controller into READY state. The current design is calling ioc facts after putting the controller into READY state, which means the driver is sending a diag reset instead of message unit reset becuase the capability information is not yet available.
Signed-off-by Kashyap Desai <[email protected]>
Signed-off-by Eric Moore <[email protected]>
---
drivers/scsi/mpt2sas/mpt2sas_base.c +2 -2
@@ -3545,11 +3545,11 @@ mpt2sas_base_attach(struct MPT2SAS_ADAPTER *ioc)return r;pci_set_drvdata (ioc->pdev, ioc->shost); - r =_base_make_ioc_ready (ioc,CAN_SLEEP ,SOFT_RESET ); + r =_base_get_ioc_facts (ioc,CAN_SLEEP );if (r) goto out_free_resources; - r =_base_get_ioc_facts (ioc,CAN_SLEEP ); + r =_base_make_ioc_ready (ioc,CAN_SLEEP ,SOFT_RESET );if (r) goto out_free_resources;